@Article{, title={Experimental and FEM Study of Coated Inserts on Cutting Forces in Orthogonal Cutting دراسة عملية وتحليلية بطريقة العناصر المحددة لتأثير طبقات كساء عدد القطع على قوى القطع في القطع المتعامد}, author={Maan A. Tawfiq and Basim S. Sahib}, journal={Engineering and Technology Journal مجلة الهندسة والتكنولوجيا}, volume={33}, number={3 Part (A) Engineering}, pages={694-702}, year={2015}, abstract={In this study, an attempt has been made to investigate and simulate the influence of coated layers, on the cutting force components in orthogonal turning process using AISI 1010 steel.A series of experimental and numerical tests have been done with four types of inserts including uncoated, coated tool with (TiN), (TiN /TiCN) and (TiN /Al2O3/ TiCN) using the special FEA code (DEFORM-2D). The turning tests were conducted at five different cutting speeds (45, 65, 97, 145, and 206 m/min.), while feed rate and depth of cut were kept constant at (0.2 mm/rev.) and (1.2 mm) respectively. The results show that the minimum force is achieved when using TiN/TiCN insert compared with other inserts in all cutting conditions. The cutting force components (tangential and feed force) are decreasedby (22% and 69% respectively) when the cutting speedincreases from (45 to 206) m/min. The maximum relative difference between simulated and measured values is less than (17%).

تضمن هذا البحث محاولة لدراسة عملية وتحليلية لمحاكاة تأثير نوع وعدد طبقات كساء عدد القطع و سرعة القطع على مركبات قوى القطع في حالة القطع المتعامد عند تشغيل صلب AISI 1010. تم اجراء مجموعة من التجارب العملية والتحليلية لاربعة انواع من لقم عدد القطع غير المكسية منها والمكسية بطبقة واحدة من (TiN) و طبقتين (TiN/TiCN) وثلاث طبقات كساء (TiN/Al2O3/TiCN). تم اختيار خمسة قيم لسرع القطع متمثلة ب(45,65,97,145 and 206 m/min.) في حين تم تثبيت قيمة معدل التغذية و عمق القطع(0.2 mm/rev.)(1.2mm) على التوالي لجميع التجارب.اظهرت النتائج بأن اقل قيمة لقوى القطع تم استحصالها عند التشغيل باستخدام عدة قطع مكسية بطبقتين (TiN/TiCN) وذلك تحت جميع ظروف القطع المذكورة اعلاه. في حالة زيادة سرعة القطع من (45m/minالى (200m/min.تقل قوة القطع بمركبتيها (المماسية وقوة التغذية) بمقدار (22%،%69) على التوالي . كما اظهرت النتائج النهائية وجود تطابق كبير للقيم العملية مع القيم التحليلية بنسبة خطأ لا تتجاوز (17%) .} }