TY - JOUR ID - TI - Effect of Separation Distance between the Columns on Punching Pattern for Flat Plates with High Strength Concrete تاثير مسافة الفصل بين الاعمدة على القص للبلاطات المسطحة ذات الخرسانة عالية المقاومة AU - Abeer Hussein Al-Shammari عبير حسين الشمري PY - 2010 VL - 14 IS - 3 SP - 162 EP - 177 JO - Journal of Engineering and Sustainable Development (JEASD) مجلة الهندسة والتنمية المستدامة SN - 25200917 25200925 AB - When a reinforced concrete slab is supported by coupled columns, these columns may behave as one column or as separated two columns according to the separation distance between them. Therefore, this study investigates the effect of separation distance of the columns on punching pattern for flat plates with high strength concrete and compares their results with other results of flat plates with normal strength concrete. Eight reinforced concrete slab specimens with coupled columns are cast with dimensions (length, width and thickness) equal to (850,470 and 50mm) by using a single high strength concrete mix with average compressive strength (f`c) that equals (55MPa) supported by coupled circular cross-section columns (diameter=85mm), these columns are located at the centerline of the slab in long direction; while in the short direction ,the positions of the columns are variable with respect to the centerline of the slab. However, the problem remains symmetric about the two axes. The specimens are tested over a simply supported span at four edges. The variable of this study is the clear distance between columns which takes the values (0.05 ,0.5 ,1 ,1.5 ,3 ,5 ,7 and 9)d ,where d is the effective depth. The test results show that ,the ultimate load reaches the maximum value when the clear distance between columns equals 9d and decreases by about (17.3 to 44.5) % of the maximum ultimate load when the clear distance between columns decreases from 7d to 0.05d .Also it is noticed that when the clear distance between columns is in the range (0.05d to 7d) ,the failure zone behaves as one zone; while when the clear distance between columns is equal to 9d , the failure zone separates into two zones. When the test results are compared with other results of flat plates with normal strength concrete(f`c=24MPa),it is concluded that ;when the concrete compressive strength factor ( )is increased by about 50% (f`c is increased from 24 to 55MPa),the ultimate loads increase by (16,17.5,20.7,21.4,31.67,31.74 and 32.84) % for the specimens from 0.05d to 9d respectively. So this study investigates the effect of separation distance of the columns on punching pattern for flat plates with high strength concrete.

عندما يكون السقف الخرساني المسلح مسند بواسطة عمودين متقاربين ,فان هذين العمودين إما أن يتصرفان كعمود واحد أو كعمودين منفصلين حسب المسافة الفاصلة بينهما . لذلك فان هذه الدر اسه تبحث تأثير مسافة الفصل ما بين الاعمده على نمط الفشل لبلاطات مسطحه ذات خرسانه عاليه ألمقاومه و مقارنتة مع بلاطات ذات خرسانة اعتيادية ألمقاومه . تتضمن الدر اسه صب ثمانية نماذج من البلاطات الخرسانية المسلحة بأبعاد (الطول , العرض والسمك) مساوية إلى(470,850و50)ملم بخرسانة ذات مقاومه تساوي 55ميغا باسكال مسنده بواسطة عمودين متقاربين مقطعهما دائري قطره يساوي 85ملم , هذين العمودين يقعان على الخط المحوري للسقف بالاتجاه الطويل , بينما بالاتجاه القصير فان موقع العمودين يكون متغير بالنسبة للخط المحوري للسقف مع الاحتفاظ بالتناظر حول المحورين. تم فحص النماذج على فضاء بسيط الإسناد من إضلاعه الأربعة. المتغير لهذه الدراسة هو المسافة ألصافيه بين العمودين والتي أخذت القيم التالية (9,7,5,3,1.5,1,0.5,0.05) من العمق الفعال . بينت نتائج الفحوصات أن حمل الفشل وصل إلى أعلى قيمة عندما أصبحت المسافة بين الأعمدة مساوية إلى 9d وتتناقص هذه القيمة بنسبة تتراوح بين (44.5-17.3) % من أقصى حمل للفشل عندما تناقصت المسافة بين الأعمدة من 7d إلى 0.05d. كذلك لوحظ انه عندما تكون المسافة الصافية بين الأعمدة بحدودd 0.05 إلى 7d فأن منطقة الفشل تنفصل عن البلاطة كجزء واحد، لكن عندما تكون المسافة الصافية ما بين الأعمدة تساوي 9d فأن عندما تم مقارنة نتائج هذا الفحص مع نتائج أخرى لبلاطات مسلحه ذات خرسانه اعتيادية المقاومة فقد تم استنتاج أن معامل مقاومة الانضغاط ( ) عندما يزداد بنسبة حوالي 50% (أي عندما تزداد f`c من 24 إلى 55 ميغا باسكال) فان تحمل ألبلاطه يزداد بنسب (16.2 ,17.54 ,20.76 ,21.37 ,31.67 ,31.75 ,32.85, 34.15)% للنماذج من d 0.05 إلىd 9 على التوالي. ER -