TY - JOUR ID - TI - Circuit Design and Implementation of Dental System Controller Based on FPGA AU - Naqa'a Luqman Mohammed PY - 2015 VL - 23 IS - 2 SP - 382 EP - 388 JO - Journal of University of Babylon مجلة جامعة بابل SN - 19920652 23128135 AB - In this paper, a hardware circuit was designed and implemented for controlling the time of dental curing system by using VHDL as a design tool and the FPGA as target technology to create a counter.The control was achieved by designing a card containing seven segment, halogen lamp and buzzer and connect these component with FPGA .The time which needed for curing to towel was controlled automatically by preset value which was input from a push –button switch. Buzzer signal used to state that the needed time of counter is over and the device was stopped from the operation.The design is implemented in a Spartan-3E Starter Kit. The speed of counter can be controlled by using the clock divider of the kit (50 MHz) to the quite clock to get the necessary delay between the numbers of counter.The advantage of using FPGA is its performance which is supported with hardware parallelism , flexibility, reliability and long time maintenance

في هذا البحث تم تصميم وتنفيذ دائرة ُسيطرة, بمكونات الكترونية مادية للسيطرة على زمن منظومة حشوة أسنان باستعمال لغة (VHDL) كوسيلة للتصميم وبمصفوفة بوابات تبرمج حقليا (FPGA) كهدف تقني لتوليد العداد.أنجزت السيطرة بتصميم بطاقة تحوي مصباح هلوجينِ،جرس والقطع السبعة وتم ربطهم مع مصفوفة بوابات تبرمج حقليا بحيث إن الزمن المطلوب لتجفيف الحشوة سيطر عليه ذاتيا عن طريق قيمة مسبقة يتم إدخالها عن طريق مفتاح زرِّ دفعِ,كذلك تم استخدام إشارة صوت أو تنبيه لتبين إن الوقت المطلوب لتجفيف الحشوة قد انتهى والجهاز توقف عن العمل.نفذ التصميم بطاقم (Spartan-3E Starter Kit, بحيث يمكن السيطرة على سرعة العداد باستعمال مقسم عداد الطاقم (clock divider) ذي التردد (50 MHz) للعد الفعلي وللحصول على تأخير بين أرقام العداد. ER -