TY - JOUR ID - TI - Wear Rate and Hardness of Boride Low Carbon Steel معدل البلى والصلادة للفولاذ الواطئ الكاربون المبورن AU - Jabbar Hussein Mohmmed جبار حسين محمد PY - 2015 VL - 21 IS - 10 SP - 90 EP - 99 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - There are no single materials which can withstand all the extreme operating conditions in modern technology. Protection of the metals from hostile environments has therefore become a technical and economic necessity. In this work, for enhancing their wear-resistance, boride layers were deposited on the surface of low carbon steel by a pack cementation method at 850 °C for (2, 4, and 6) h using vacuum furnace. The boronizing process was achieved using different concentration of boron source (20, 25, and 30) % wt. into coating mixture to optimize the best conditions which ensure the higher properties with lower time. The coating was characteristic by X ray diffraction (XRD), and it is confirmed the presence of (Fe2B) and (FeB) in the coating. The wear rate, hardness and thickness of the boride layers were measured, and it was observed that they effected by concentration of boron and time holding of boronizing process. Experimental results show that the higher properties of coating layer were obtained with 30% wt. of boron concentration and 4 h time holding.

لا توجد مادة مفردة ممكن ان تتحمل ظروف التشغيل القاسية في التكنلوجيا الحديثة. لذلك, حماية المعدن من المحيط القاسي اصبح ضرورة تقنية واقتصادية. في هذا العمل، ولتحسين مقاومتها للبلى، تم ترسيب طبقات من البوريد على سطح الفولاذ المنخفض الكاربون باستخدام طريقة السمنتة الصلبة عند درجة حرارة 850 ْم ولازمان (2، 4، و6) ساعات باستخدام فرن مفرغ. تم اجراء عملية البورنة باستخدام تراكيز مختلفة لمصدر البورون (20، 25، و30) % من الوزن داخل خليط الطلاء للحصول على أفضل القيم لأفضل ظروف للحصول على أعلى خواص بأقل زمن. تم توصيف الطلاء باستخدام حيود الاشعة السينية وقد اثبتت وجود طوري (Fe2B) و(FeB) في الطلاء. تم قياس معدل البلى، الصلادة، وسمك طبقة البوريد، وقد لوحظ تأثرها بتركيز البورون وزمن الابقاء لعملية البورنة. اثبتت النتائج العملية ان افضل خواص ممكن الحصول عليها عند الطلاء ب 30 % من الوزن تركيز البورون مع زمن ابقاء 4 ساعات. ER -