TY - JOUR ID - TI - Effect of Gamma Ray Irradiation on Structural and Optical Properties of ZnO Thin Films تأثير التشعيع بأشعة كاما في الخواص التركيبية والبصرية لاغشية ZnO الرقيقة AU - Bushra K. H. Al-Maiyaly بشرى كاظم حسون الميالي PY - 2015 VL - 28 IS - 3 SP - 7 EP - 17 JO - Ibn Al-Haitham Journal For Pure and Applied Sciences مجلة ابن الهيثم للعلوم الصرفة والتطبيقية SN - 16094042 25213407 AB - In this research, the structural and optical measurements were made on the Zinc oxide(ZnO) films prepared by two methods once by using chemical spray pyrolysis technique, andanother by using thermal evaporation technique before and after irradiation by Gamma –Ray(γ – rays) from source type (Cs 137) with an energy (0.611)MeV as a function of gamma dose(0.15,0.3 and 0.45) Gy. The thickness of all films prepared by two method was about (300 ±50) nm.XRD is used to characterize the structural properties, the results demonstrated that allsamples prepared by two method before and after irradiation have polycrystalline structurewith a preferred orientation (002).Also it showed that the structural properties are weaklydependent on the gamma dose. The optical measurement shows that all ZnO films preparedby two method have a direct energy gap, and they in general decrease with the increase ofGamma dose while the optical constant such as absorption coefficient, refractive index,extinction coefficient, real and imaginary parts of the dielectric constant and opticalconductivity showed an opposite trend, these values increase with the increase of irradiationdose. As well as all optical properties for the samples prepared by thermal evaporationtechnique is higher than the samples prepared by chemical spray pyrolysis technique

أجريت القياسات التركيبية والبصرية لاغشية أوكسيد الزنك (ZnO) في هذا البحث المحضرة بطريقتين واحدة باستعمال طريقة الرش الكيميائي الحراري والاخرى باستعمال طريقة التبخير الحراري قبل وبعـد التشعيع. باشـعة كامـا من مصـدر (Cs137) بطاقة (0.611) MeV بجرع اشعاعية مختلفة (0.15,0.3 and 0.45) Gy. وكانت جميع الاغشية المحضرة بكلا الطريقتين بسمك 300  50) nm) واستعملت XRD لايجاد الخصائص التركيبية واكـدت النتائج ان لجميـع النمـاذج المحضـرة بكلا الطريقتين قبل وبعـد التشعيع تركـيب متعدد التبلور بـأفضلية للاتجاه (002) وان الخصائص التركيبية قليلة الاعتماد على جرعة الاشعاع . وبينت القياسات البصرية ان لاغشية (ZnO) المحضـرة بكلا الطريقتين فجوة طاقة مباشرة وتقل قيمتها بصورة عامة بزيادة جرعة الاشعاع بينما اظهرت الثوابت البصرية مثل معامل الامتصاص ومعامل الانكسار ومعامل الخمود وثابت العزل الكهربائي بجزئيه الحقيقي والخيالي والنوصيلية الضوئية سلوك معاكس اذ ازدادت قيمهم بزيادة جرعة الاشعاع .وأظهرت الخصائص البصرية للنماذج المحضرة بطريقة التبخير الحراري قيم اعلى من النماذج المحضرة بطريقة الرش الكيميائي الحراري. ER -