@Article{, title={Experimental Behavior of Steel-Concrete-Steel Sandwich Beams with Truss Configuration of Shear Connectors السلوك التجريبي للعتبـات السندوجية حديد-خرسانة-حديد مع روابط قصية بهيئة مسنم}, author={Thaar Saud Salman Al-Gasham ثائر سعود سلمان الغشام}, journal={Journal of Engineering مجلة الهندسة}, volume={22}, number={4}, pages={18-29}, year={2016}, abstract={This paper presents experimentally a new configuration of shear connector for Steel-Concrete-Steel (SCS) sandwich beams that is derived from truss configuration. It consists of vertical and inclined shear connectors welded together and to cover steel plates infilled with concrete. Nine simply supported SCS beams were tested until the failure under a concentrated central load (three- point bending). The beams were similar in length (1100mm), width (100mm), and the top plate thickness (4mm). The test parameters were; beam thickness (150, 200, 250, and 300mm), the bottom plate thickness (4, and 6mm), the diameter of the shear connectors (10, 12, and 16mm), and the connector spacing (100, 200, and 250mm). The test results showed that the stiffness of SCS beam augmented with the increase in beam thickness, lower plate thickness, and connector diameter while it decreased with increasing the connector spacing. The ultimate load capacity of the SCS beams increased to 72.2% and 42.1% by enlarging the beam thickness and connector diameter to 100% and 60%, respectively. Increasing the connector spacing of 150% led to a considerable reduction in the ultimate load reached to 68.4%. Finally, the ultimate strength was not affected by augmenting the bottom plate thickness up to 50%.

في هذا البحث تم تقديم هيئة جديدة( هيئة المسنم) للروابط القصية في العتبات السندوجية بشكل تجريبي . هذه الهيئة تتكون من روابط قصيه عمودية ومائلة مرتبطة مع بعضها ومع الصفائح الحديدية بواسطه اللحام مملوءه بالخرسانة. تم فحص تسع عتبات بسيطة الاسناد الى حد الفشل تحت تأثير حمل مركز مسلط في منتصف العتبة. هذه العتبات متشابهة في الطول (1100 ملم) و العرض (100ملم) وسمك الصفيحة العلوية (4ملم) . متغيرات الفحص تضمنت سمك العتبات ( 150 و 200 و 250 و 300 ملم ) وسمك الصفيحة السفلية ( 4 و 6 ملم ) وقطر الروابط القصية ( 10 و 12و 16 ملم ) ومسافات الروابط القصية ( 100 و 200 و 250 ملم) . نتائج الفحص بينت , أن صلابة العتبات تزداد مع زيادة كلاً من سمك العتبة وسمك الصفيحة السفلية وقطر الروابط القصية في حين أنها تقل مع إزدياد المسافات بين الروابط القصية . أن الحمل الاقصى للعتبات قد أزداد بحدود 72.2 % و 42.1% عند ازدياد سمك العتبة وقطر الرابط القصي الى 100% و 60% على التوالي. زيادة مسافات الروابط القصية الى 150% أدى الى نقصان كبير في الحمل الاقصى وصل الى 68.4% . اخيراً الحمل الاقصى لم يتأثير بزيادة سمك الصفيحة السفلية بحدود 50%.} }