TY - JOUR ID - TI - Strengthening of Reinforced Concrete Beam in Shear Zone by Compensation the Stirrups with Equivalent External Steel Plates AU - Khamail Abdul-Mahdi Mosheer AU - Alaa Hadi Hameed Hassoon PY - 2016 VL - 24 IS - 3 SP - 604 EP - 616 JO - Journal of University of Babylon مجلة جامعة بابل SN - 19920652 23128135 AB - An experimental study on reinforced concrete beams strengthened with external steel plates instead of shear stirrups has been held in this paper. Eight samples of the same dimensions and properties were used. Two of them were tested up to failure and specified as references beams; one with shear reinforcement and the other without shear reinforcement. Another samples without shear reinforcement were tested until the first shear crack occurs, then the samples strengthened on both sides with external steel plates as equivalent area of removed stirrups. The strengthened beams were divided into three groups according to the thickness of plates (1, 1.5, 2) mm, each group involved two beams; one bonded using epoxy and the other bonded using epoxy with anchored bolts. Finally, the strengthened beams tested when using anchored bolts with epoxy glue to bond plates. Where the increasing in maximum load is higher than that in reference beam with no internal stirrups reach to (75.46 –106.13)% and has a good agreement with the control beam with shear reinforcement reach to (76.06 – 89.36)% of ultimate load.

في البحث الحالي تم دراسة استخدام الصفائح الحديدية من الخارج لتقوية العتبات الخرسانية المسلحة عند منطقة القص للتعويض عن الاتاري في حالة عدم وجودها. تم فحص ثمانية نماذج بنفس الابعاد والخواص. أثنان من هذه النماذج تم تحميلها الى حد الفشل واستخدمت كمراجع , احداهما يحتوي على تسليح قص والاخر بدونه. بقية العتبات لا تحتوي على تسليح قص وقد تم تحميلها الى حين ظهور اول شق في العتب ليتم بعدها تقوية العتبات باستخدام الصفائح الحديدية من الخارج وبمساحة مكافئة للأتاري المفقود. أستخدمت صفائح حديدية بسمك 1ملم , 1.5 ملم , و 2ملم وتم ربط كل نوع من هذه الصفائح مع سطح العتبات مره باستخدام غراء الايبوكسي فقط ومرة اخرى باستخدام غراء الايبوكسي مع البراغي. بعد اكمال عملية تقوية العتبات تم اعادة تحميلها مرة اخرى وصولا الى الفشل. جميع العتبات المقواة اظهرت تحسنا ملحوظا في المقاومة وخصوصا عند استخدام البراغي مع الايبوكسي لتثبيت الصفائح. حيت وصلت الزيادة في التحمل الى (75.46 –106.13)% عن العتب المرجعي الذي بدون تسليح قص. واظهرت توافقا جيدا مع العتب الذي يحوي تسليح قص وصل الى (76.06 – 89.36)%من تحمله الاقصى. ER -