TY - JOUR ID - TI - SIMULATION OF THE WETTING PATTERN UNDER SURFACE DRIP IRRIGATION AND GRAVEL GROOVE محاكاة لجبهة الابتلال تحت الري بالتنقيط السطحي وبأخدود مملوء بالحصى AU - Younis Mohammad Hassan يونس محمد حسن AU - Ahmed Shihab Ahmed احمد شهاب احمد AU - Sabah Anwer Almasraf صباح أنور داوود المصرف PY - 2016 VL - 9 IS - 4 SP - 71 EP - 82 JO - DIYALA JOURNAL OF ENGINEERING SCIENCES مجلة ديالى للعلوم الهندسية SN - 19998716 26166909 AB - A groove filled with gravel under the soil surface is presented in this research to study the influence of groove’s dimensions and emitter’s discharge on the wetting pattern directions in the heavy soil under surface drip irrigation systems. Dimensional analysis techniques were used for predicting the wetting pattern directions functions and the comparison with the experimental work was carried out. The laboratory tests were conducted in a clay loam soil steel container using groove filled with gravel under the soil surface of width 10 cm and 20 cm and at emitter’s discharge 1.3 l/hr and 2 l/hr. The results showed that the groove’s width has effected on dimensions of the wetting patterns front. The increasing of the groove’s width caused increase in the soil water movement in downward and horizontal directions by an average value of 19.1% and 8.9%, respectively. Also, the increasing of the groove’s width had an inverse effect on the water upward direction; the average value dropped by 19.9%. Moreover, increasing value of the emitter’s discharge influenced on the increasing and decreasing of the upward, horizontal and downward water directions. Increasing of the emitter’s discharge, saturation state was taken place inside the groove due to the clay particles in the soil. The statistical analysis for the comparison among the predicted wetting patterns equations developed by the dimensional analysis techniques with the experimental measured data showed a good agreement. The RMSE and R2 were varied from 1.18 cm to 1.847 cm and from 0.98 to 0.99, respectively.

أستعرض في هذا البحث أستعمال أخدود مملوء بالحصى تحت سطح تربة مزيجية طينية تحت نظام الري بالتنقيط السطحي لغرض دراسة تأثير أبعاد الاخدود وتصريف المنقطات على أتجاهات جبهة دالة الابتلال في التربة الثقيلة. أستخدمت تقنية التحليل البعدي لاستنباط دالات أتجاهات جبهة الابتلال ومقارنة ذلك مع العمل المختبري. أجريت الاختبارات المختبرية في حاوية مصنوعة من الحديد مملوءة بالتربة الطينية المزيجية وبأستخدام أخدود مملوء بالحصى بعرض 10 و20 سم وبتصريف عند المنقط 1.3 و2 لتر. ساعة-1. أظهرت النتائج بأن عرض الاخدود له تأثير على تقدم جبهات الابتلال. حيث أن الزيادة في عرض الاخدود أثرت في زيادة حركة دالة التقدم بالاتجاه نحو الاسفل والافق وبمعدل 19.1% و8.9% على التوالي. كما كانت الزيادة في عرض الاخدود له الاثر المعاكس على حركة أتجاه المياه نحو الاعلى وبمعدل نقصان قدره 19.9%. أضافة الى أن الزيادة في تصريف المنقط له تأثير على زيادة ونقصان أتجاهات دالة التقدم نحو الاعلى والافق والاسفل. أن هذه الزيادة ستجعل من حالة التشبع هي الحالة السائدة داخل الاخدود وذلك نتيجة وجود حبيبات الطين داخل التربة. أظهر التحليل الاحصائي للمقارنة بين المعادلات المستنبطة لدالة الابتلال لكافة الاتجاهات وبأستخدام تقنية التحليل البعدي مع البيانات المختبرية المقاسة بانه تطابق جيد، حيث كانت قيم معدل الجذر المربع للخطأ ومعامل الارتباط بين 1.18 الى 1.847 سم وبين 0.98 الى 0.99 على التوالي. ER -