TY - JOUR ID - TI - Computational Fluid Dynamics (CFD) Modeling Study of Thermal Performance for Multipurpose Solar Heating System دراسة نمذجة ديناميات الموائع الحسابية (CFD) للأداء الحراري لمنظومات التسخين الشمسي متعددة الاغراض AU - Audai Hussein Al-Abbas عدي حسين كاظم العباس PY - 2017 VL - 20 IS - 1 SP - 222 EP - 234 JO - Al-Nahrain Journal for Engineering Sciences مجلة النهرين للعلوم الهندسية SN - 25219154 25219162 AB - The 3-D numerical simulations of the thermal collectors in solar heating systems were conducted to simulate the conventional solar heating system, multipurpose solar water heater (MPSWH), and multipurpose solar air heater (MPSAH). The commercial computational fluid dynamics (CFD), AVL Fire ver. 2009.2 was used to solve and investigate the temperature distributions in the absorber plate and riser tube of both solar water and air heater during summer and winter seasons. The RNG k - turbulence model was employed for this CFD study. The present paper was to provide a good understanding of thermal performance for the solar collector at different operating conditions. The experimental setup and physical data of Venkatesh, R. and Christraj, W. [15] were employed as geometric parameters and initial boundary conditions to model and to validate the predicted numerical values. Comparing to the values of temperatures for the conventional SWH and SAH, the predicted results of the MPSWH and the MPSAH showed a good improvement on the thermal performance. These enhancements on the temperature may have been due to the new design adopted in the multipurpose solar heating systems by using riser tubes and headers to the original design of the thermal systems. Additionally, the thermal performance of solar collectors increases with increasing the mass flow rates and thermal conductivity of absorber plate. For validation aspect, the predicted results of all cases examined showed a good agreement against the measured results in terms of temperature distribution levels and thermal efficiencies.

ان المحاكاة العددية ثلاثية الابعاد للجامع الحراري في انظمة التسخين الشمسي قد نفذت لمحاكاة انظمة التسخين الشمسي التقليدي و انظمة التسخين الشمسي المائي متعدد الاغراض (MPSWH) و انظمة التسخين الشمسي الهوائي متعدد الاغراض (MPSAH).ان برنامج ديناميك الموائع الحسابية التجاري (CFD) AVL Fire ver. 2009.2 قد استخدم لحل وتفحص توزيعات درجات الحرارة في لوحة امتصاص وأنبوب الناهض في كل من MPSWH وMPSAH خلال فصل الصيف والشتاء. ان موديل الجريان الاضطرابي k - RNG قد وظف في هذه الدراسة العددية. ان الغاية من البحث الحالي هي للتزود بمعلومات جيدة لزيادة الاداء الحراري لمنظومات التسخين الشمسي في مختلف شروط العمل. قد تم استخدام البيانات العملية من المصدر ]15[ كمدخلات للبرنامج الحسابي. مقارنتا الى القيم العليا لدرجات الحرارة في منظومات التسخين المائي والهوائي التقليدية (SWH و SAH) , كانت النتائج العددية ل MPSWH و MPSAH افضل على الاداء الحاري للمنظومة. هذه التحسينات على قيم درجات الحرارة حدثت بسبب التصميم الجديد المعتمد في أنظمة التدفئة الشمسية متعددة الأغراض باستخدام أنابيب الناهض والرؤوس إلى التصميم الأصلي للأنظمة الحرارية. بالإضافة إلى ذلك، فإن الأداء الحراري لجامع الطاقة الشمسية يزداد مع زيادة معدلات التدفق والتوصيل الحراري من لوحة الامتصاص. لغرض التحقيق من النتائج العددية, أظهرت النتائج المتوقعة لجميع الحالات التي تم فحصها اتفاق جيد ضد النتائج العملية من حيث مستويات توزيع درجة الحرارة والكفاءة الحرارية. ER -