TY - JOUR ID - TI - PORE FORMATION DURING SINTERING OF TWO DIFFERENT COMPOSITES MATERIALS(Fe-Cu)&(Fe-Cu-C) AND ITS EFFECTS ON WEAR BEHAVIOR تكوين المسامات أثناء التلبيد لمادتين مركبتين مختلفتين(Fe-Cu-C, Fe-Cu) وتأثيرها على سلوك البلى AU - Khansaa Dawood Salman AU - Muhannad Zedain Khalifa AU - Asifa Mahdi Mohammd PY - 2016 VL - 20 IS - 5 SP - 64 EP - 74 JO - Journal of Engineering and Sustainable Development (JEASD) مجلة الهندسة والتنمية المستدامة SN - 25200917 25200925 AB - : The effect of pores in Fe- Cu and Fe-Cu-C generated by sintering with solid state has been studied. The additive alloying elements Cu & C and the size of the pores were affected on wear rate, there for the carbon reduces wear rate, and larger pore lowing wear rate. Geometrical distributions of the secondary pores were independent on Cu and C fraction used. Structural materials sintered with solid state and Argon atmosphere (Ar), it seems therefore desirable to use as fine alloying powders as possible to attain optimum wear resistance. This work was done by two stages: First stage, pore formation during sintering with two different additive alloying elements Cu & C. While the second stage wear test was performed by using pin-on- disc machine for different loads (2, 4, 6 and 8 N) to each composite material used in this work under dry sliding conditions. The results showed that obviously improvement in wear resistance for C additive alloying element more than Cu.

تمت دراسة تأثير المسامات الناتجة عن التلبيد بالحالة الصلبة في Fe-Cu و.Fe-Cu-C أن عناصر السبك المضافة C & Cu وحجم المساماتالمتكونة توثر على معدل البلى, لذا فان وجود الكاربون يقلل من معدل البلى ,وكذلك كلما كبر حجم المسامات قل معدل البلى. ان توزيع المسامات الثانوية لا يعتمد على الكسر ألحجمي لدقائق C & Cu المستخدمة وقد تبين أن التلبيد بالحالة الصلبة في جومن الاركون((Ar يفضل عند استخدام مساحيق سبائكية ناعمة قدر الإمكان للحصول على مقاومة البلى المثلى .تم إجراء البحث على مرحلتين: المرحلة الأولى : تكوين المسامية أثناء التلبيد لعناصر السبك المختلفة المضافةCu & C .بينما المرحلة الثانية : تم إجراء اختبار البلى باستخدام ماكنة المسمار – على – القرصعند أحمال مختلفة 8,6,4,2) نيوتن)لكل مادة مركبة مستخدمة في البحث تحت تأثير ظروف الانزلاق الجاف. أظهرت النتائج تحسن واضح في مقاومة البلى باستخدام C كعنصر سبك مضاف أكثر من Cu ER -