@Article{, title={Study the affect of Silica on the physical and electrical properties of Alumina (Al2O3) دراسة تأثير السليكا على الخواص الفيزيائية والكهربائية للالومينا(Al2O3 )}, author={Hani mahmood hussien هاني محمود حسين}, journal={Al-Qadisiyah Journal of Pure Science مجلة القادسية للعلوم الصرفة}, volume={14}, number={1}, pages={139-153}, year={2009}, abstract={The research concerns with physical properties (linear firing shrinkage ,bulk density ,open porosity , and water absorption ) and electrical properties up to 1 MHz ( dielectric constant ,electrical conductivity and power factor ) of samples prepared from Alumina powder with Quartz additives .Samples were pressed at pressure 50 MPa by using a mould has diameter 5 cm and fired at temperature 1500 OC with maturing time 2.5 hr . The research ,in the course of studying the above properties , aims to an accurate clarifying to the effect of Quartz additives percentage (5 %, 10% , 20 % , and 30 % )on the physical and electrical properties Alumina.It was found that the water absorption and open porosity decreased with increasing of Quartz additives .Also ,it was found clearly decreasing in linear shrinkage (from 5 % to 4.2 % ) at Quartz additives 5 % and 10 % ; while the variation was a trace at 20 % and 30 % ( from 4.6 % to 4.5 % ) respectively .Also , it was found decreasing of bulk density with increasing of Quartz additives up to 10 % from 1.518 gm/cm3 to 1.434 gm/cm 3 then it increased with increasing of Quartz up to 30 % from 1.541 gm/cm3 to 1.586 gm/cm 3 . In relation to electrical properties ,at the frequency 1 KHz , it was found that 5 % of Quartz additives result in maximum values of dielectric constant and power factor and electrical conductivity. The same behavior was found at 1 MHz except dielectric constant; while the 30 % of Quartz additives gave maximum dielectric constant(3.15 ) and minimum electrical conductivity and power factor (4.47*10 -8ohm-1.cm-1 ,0.0255) respectively .In general it was found ,through the curves of electrical properties with increasing of Quartz additives , that the ratio 5 % gave larger values of electrical conductivity within the extent of frequency from 200 Hz to 1 MHz ,then it decreased at the additives 10 % and 20 % .While at ratio 30 % gave minimum values of electrical conductivity compared to Alumina. The same behavior was found relative to power factor curves.

درس في هذا البحث الخواص الفيزيائية (التقلص الخطي للحرق ,الكثافة الحجمية ,المسامية المفتوحة وامتصاصية الماء) والخواص الكهربائية لغاية تردد MHz 1 (ثابت العزل الكهربائي ,التوصيلية وعامل القدرة ) لنماذج سيراميكية محضرة من مسحوق الالومينا مضافا إليها نسب من الكوارتز .إذ كبست النماذج بضغط MPa 50 بقالب قطره cm 5 ولبدت بدرجة حرارة OC 1500 بزمن إنضاجhr 2.5 .يهدف البحث خلال دراسة الخواص المذكورة أعلاه إلى تشخيص دقيق لتأثير زيادة نسبة الكوارتز والتي كانت 5 %,10%,20% و30% في خواص الالومينا الفيزيائية والكهربائية.إذ وجد إن امتصاصية الماء والمسامية المفتوحة تفل بشكل عام بزيادة نسبة الكوارتز.كما وان التقلص الخطي للحرق يقل بشكل ملحوظ (من 5% إلى 4.2% ) عند النسب 5%و10%فيما يكون التغير طفيف جدا عند النسب 20%و30% إذ يكون التقلص الخطي (4.6%و4.5) على التوالي.ووجد أيضا إن قيم الكثافة الحجمية للنماذج تقل مع زيادة نسبة الكوارتز لغاية 5% من gm/cm3 1.518 إلى gm/cm3 1.434 ثم تزداد بزيادة نسبة الكوارتز لغاية 30% من gm/cm3 1.541 إلى gm/cm31.586.أما الخواص الكهربائية فقد وجد إن عند التردد KHz 1 وعند النسبة 5% من السليكا تكون أعظم قيمة لثابت العزل وعامل القدرة والتوصيلية الكهربائية .ووجد السلوك ذاته عند التردد 1 MHz باستثناء ثابت العزل .في حين عندما تكون نسبة السليكا 30% وعند التردد 1 MHz نحصل على أعلى قيمة لثابت العزل (3.15 ) يقابلها اقل قيمة للتوصيلية الكهربائية وعامل القدرة (4.47*10-8Ohm-1cm-1 ,0.0255 ) على التوالي .وبشكل عام وجد من خلال دراسة منحنيات الخواص الكهربائية أنه مع زيادة نسبة السليكا بان قيم التوصيلية تزداد بشكل كبير عند النسبة 5% في مدى الترددات من 200Hz إلى 1MHz مقارنة مع الالومينا ,ثم تبدءا تتناقص عند النسب 10% و20% ,وعند النسبة 30% نحصل على اقل قيمة للتوصيلية الكهربائية مقارنة بالالومينا .ووجد السلوك ذاته في منحنيات عامل القدرة.} }