TY - JOUR ID - TI - Sensitivity of Ce doped CuO for NO2 gas تحسسية أوكسيد النحاس المطعم بالسيريوم لغاز ثاني أوكسيد النتروجين (NO2) AU - Isam M. Ibrahim عصام محمد ابراهيم AU - Jobair A. Najim جبير عبدالله نجم AU - Aws M. Rakea أوس موفق راكع PY - 2017 VL - 15 IS - 35 SP - 64 EP - 74 JO - Iraqi Journal of Physics المجلة العراقية للفيزياء SN - 20704003 26645548 AB - In this work the structural, optical and sensitive properties of Cerium - Copper oxide thin film prepared on silicon and glass substrate by the spray pyrolysis technique at a temperature of (200, 250, 300 °C). The results of (XRD) showed that all the prepared films were of a polycrystalline installation and monoclinic crystal structure with a preferable directions was (111) of CuO. Optical characteristics observed that the absorption coefficient has values for all the prepared CuO: Ce% (104 cm-1) in the visible spectrum, indicating that all the thin films prepared have a direct energy gap. Been fabrication of gas sensors of (CuO: Ce %) within optimum preparation conditions and study sensitivity properties were examined her exposed to nitrogen dioxide (NO2) with concentration ratio of 3 %, at operating temperatures (R.T, 200 and 300 °C). It is found that the maximum sensitivity at concentration value (Ce=50 %) which it is equal to (39.15 %) at operating temperature (300 °C).

تم في هذا البحث مناقشة الخصائص التركيبية، البصرية والتحسسية لأغشية أوكسيد السيريوم - أوكسيد النحاس الرقيقة المرسبة على قواعد من السليكون والزجاج بواسطة تقنية التحلل الكيميائي الحراري في درجات حرارة مختلفة ( ̊C300 ،250 ،200) وأظهرت نتائج حيود الاشعة السينية (XRD) أن جميع الاغشية المحضرة تمتلك تركيب متعدد التبلور (polycrystalline) أحادية الميل (monoclinic) وان الاتجاه المفضل هو (111). ولوحظ من الخصائص البصرية ان قيمة معامل الامتصاص لجميع اغشية (CuO:Ce) هي (104 cm-1) في منطقة الطيف المرئي وهذا يعني ان جميع الاغشية الرقيقة المحضرة تمتلك فجوة طاقة مباشرة. تم تصنيع خلية متحسس غاز من اغشية (CuO:Ce) ضمن ظروف التحضير المثلى وتم دراسة الخواص التحسسية لها بتعريضها لغاز ثاني اوكسيد النتروجين ((NO2 بنسبة 3 %، و ان افضل درجة حرارة تشغيل للمتحسس هي 300 °C) و(200 . وجد ان اعظم قيمة للحساسية عند نسبة اضافة (Ce=50%) والتي تساوي (39.15%) عند درجة حرارة (300 °C). ER -