@Article{, title={Effect of Single and Double Pass Arc Welding on HAZ of High Carbon Steel Weldments}, author={Alaa Abdul Hasan Atiyah and Shaker J. Edrees and Farhad M. Kushnaw}, journal={Journal of University of Babylon مجلة جامعة بابل}, volume={26}, number={2}, pages={141-151}, year={2018}, abstract={Measurements of heat affected zone width for multi high carbon steel joint in case of single and double pass arc welded have been studied. These measurements are carried out in accompanying of hardness and microstructural observations. Knowing that, high carbon steel has a poor weld ability and most of welding processes are carried out for repairing components. It is found that a preheating was a very important parameter in identifying the width of heat-affected zone. Preheating the joint at 450°C was found to gives less width heat affected zone (i.e.5.93mm) in the case of single pass welding practices. While, in the case of double pass welding, the heat affected zone becomes wider because the excessive heating during welding cycle. The double pass welding has coarsening the structure of first pass. Microscopic observations indicated that the structure of HAZ of high carbon steel was mainly lath martensite (ML) under the condition of lower weld heat input.

تم في هذا البحث قياس عرض المنطقة المتأثرة بالحرارة في حالة وصلات اللحام للفولاذ العالي الكاربون والذي تم لحامه بواسطة القوس الكهربائي بواقع تمريره واحدة وتمريرتان. إجريت هذه القياسات وفقا الى مراقبة البنية المجهرية والى قياسات قيم الصلادة لهذه الوصلات. علما إن الفولاذ عالي الكاربون هو واطي أللحامية وان معظم عمليات لحامه تتركز في عمليات التصليح للأجزاء. وقد وجد في هذا البحث إن عملية التسخين المسبق تعتبر عاملا مهما في تحديد عرض المنطقة المتأثرة باللحام. وقد كان تسخين الوصلة إلى درجة حرارة (°450) درجة مئوية يعطي اقل عرض للمنطقة المتأثرة بالحرارة حوالي ((5.93mm في حالة وصلة التمريرة الواحدة. بينما في حالة التمريرتان فأن المنطقة المتأثرة بالحرارة أصبحت اعرض(6.8mm) عند نفس ظروف ودرجة حرارة التسخين المسبق وذلك بسبب تعرضها للتسخين المضاعف أثناء التمريرة الثانية. وان الوصلات الملحومة بتمريرتان ذات بنية مجهرية اخشن من حالة الوصلات الملحومة بتمريره مفردة. كما أظهرت فحوصات المجهر الضوئي أن طور المارتنسايت يتكون في المنطقة المتأثرة بالحرارة تحت ظروف طاقة اللحام المنخفضة.} }