TY - JOUR ID - TI - Investigation of CNC Milling Machining Parameters on Surface Roughness تأثير متغيرات التشغيل في مكائن التفريز المبرمجة على الخشونة السطحية AU - Rasha Ramiz Alyas رشا رامز الياس PY - 2018 VL - 14 IS - 3 SP - 123 EP - 128 JO - Al-Khwarizmi Engineering Journal مجلة الخوارزمي الهندسية SN - 18181171 23120789 AB - Milling Machining is a widely accepted nontraditional machining technique used to produce parts with complex shapes and configurations. The material is removed in two stages roughing and finishing, the flat end cutter removed the unwanted part of material, then finished by end mill cutter. In milling technique, the role of machining factors such as cutting depth, spindle speed and feed has been studied using Taguchi technique to find its effectiveness on surface roughness. Practical procedure is done by Taguchi Standard matrix. CNC milling is the most conventional process which is used for removing of material from workpiece to perform the needed shapes. The results and relations indicate that the rate of feed is very important factor for modeling surface roughness. The plot of S/N ratio shows that the optimum combination of the milling factors that gives the best value of surface accuracy. The best combination of milling factors has also been predicted to minimize the surface roughness.

مكائن التفريز هو أكثر تقنية مقبولة للقطع التقليدي المستخدمة لإنتاج أجزاء لأشكال معقدة. ازالة المادة تتم على مرحلتين القطع الخشن والانهاء السطحي، القطع الخشن يتم استخدام عدة قطع ذونهاية مسطحة وإزالة الجزء المطلوب من العينة، ثم في الانهاء السطحي يتم استخدام عدة قطع ذو نهاية مستديرة. في هذا البحث، تم دراسة تأثير عوامل التشغيل مثل عمق القطع وسرعة القطع والتغذية باستخدام تقنية تاكوشي لإيجاد افضل قيم للخشونة السطحية. يتم تحديد الجزء العملي من قبل مصفوفة تاكوشي القياسية. التفريز بالمكائن المبرمجة هو العمليات الأكثر تقليدية التي تستخدم لإزالة المعدن من المشغولة لانتاج الأشكال المطلوبة. النتائج والعلاقات تشير إلى أن معدل التغذية هو عامل مهم جدا للتأثير على خشونة السطح. وتظهر نسبة الاشارة للخشونة الى معدل الخطأ تعطي الأمثل بين عوامل القطع التي تعطي أفضل قيمة لدقة السطح. كما تم توقع أفضل عوامل التي تعطي افضل خشونة سطحية. ER -