TY - JOUR ID - TI - Study of Raw Materials for Manufacturing Perforated Clay Bricks (Chamchamal, and Qaradagh Regions in Sulaimani/ Iraq) دراسة مواد أولية لتصنيع الطابوق الطيني المثقب (في مناطق جمجمال وقرداغ في السليمانية / العراق) AU - Kamal Ahmad Rashed كمال أحمد رشيد PY - 2017 VL - 4 IS - 4 SP - 51 EP - 67 JO - Sulaimania Journal for Engineering Sciences مجلة السليمانية للعلوم الهندسية SN - 24101699 24156655 AB - There is no information about the optimum molding moisture content and molding pressure on the physical and mechanical properties of clay bricks. In this paper, the effect of moisture content and applied pressure during molding of brick samples for two selected locations of Sulaimani province in Iraq were studied. After firing the molded brick samples at a temperature of 1000oC, the physical and mechanical properties were studied from the following tests: firing shrinkage, water absorption, dry density and uniaxial compressive strength. The results indicate that the optimum moisture content for molding and manufacturing of clay bricks is within (0.6 to 0.7) of plastic limit of the raw materials. Also, it was found that the sufficient applied pressure during molding of clay bricks is 6 MPa.

لا توجد معلومات كافية حول تأثير الرطوبة والضغوط التي تستخدم أثناء الصب على الخصائص الفيزيائية والميكانيكية للطابوق الطيني. تم في هذا البحث دراسة تأثير نسبة الرطوبة والضغوط التي تستخدم أثناء صب عينات الطابوق في موقعين مختارين في محافظة السليمانية. وبعد حرق عينات من الطابوق المصبوب عند درجة حرارة ( 1000ە م )، تم التعرف على الخواص الفيزيائية والميكانيكية باستخدام الاختبارات التالية: الانكماش الحراری ، امتصاص الماء ، الكثافة الجافة وقوة الضغط ذو محورين. وتشير النتائج أن نسبة الرطوبة المثالية لحد اللدونة للمواد الخام أثناء صب وتصنيع الطابوق الطيني هي ( 0.6 - 0.7 ). اضافة الى ذلك فقد وجد أن الضغط الكافي أثناء صب الطابوق الطيني هو 6 ميجا باسكال. ER -