TY - JOUR ID - TI - Petrophysical Properties of an Iraqi Carbonate Reservoir Using Well Log Evaluation الخواص البتروفيزيائية لمكامن الكاربونيت العراقية باستخدام تقييم سجل الآبار AU - Sara S. Zughar ساره صالح زغير AU - Ahmad A. Ramadhan احمد عبد الله رمضان AU - Ahmed K. Jaber احمد خليل جبار PY - 2020 VL - 21 IS - 1 SP - 53 EP - 59 JO - Iraqi Journal of Chemical and Petroleum Engineering المجلة العراقية للهندسة الكيمياوية وهندسة النفط SN - 19974884 26180707 AB - This research was aimed to determine the petrophysical properties (porosity, permeability and fluid saturation) of a reservoir. Petrophysical properties of the Shuiaba Formation at Y field are determined from the interpretation of open hole log data of six wells. Depending on these properties, it is possible to divide the Shuiaba Formation which has thickness of a proximately 180-195m, into three lithological units: A is upper unit (thickness about 8 to 15 m) involving of moderately dolomitized limestones; B is a middle unit (thickness about 52 to 56 m) which is composed of dolomitic limestone, and C is lower unit ( >110 m thick) which consists of shale-rich and dolomitic limestones. The results showed that the average formation water resistivity for the formation (Rw = 0.021), the average resistivity of the mud filtration (Rmf = 0.57), and the Archie parameters determined by the picket plot method, where m value equal to 1.94, n value equal to 2 and a value equal to 1. Porosity values and water saturation Sw were calculated along with the depth of the composition using IP V3.5 software. The interpretation of the computer process (CPI) showed that the better porous zone holds the highest amount of hydrocarbons in the second zone. From the flow zone indicator method, there are four rock types in the studied reservoir.

يهدف البحث إلى تحديد الخواص البتروفيزيائية (المسامية والنفاذية وتشبع السوائل) للمكمن. يتم تحديد الخواص البتروفيزيائية لتكوين الشعيبة في حقل Y من تفسير بيانات السجل المفتوح لأبار (X-1 و X-2 و X-4 و X-5 و X-13 و X-14). اعتمادًا على الخواص البتروفيزيائية ، يمكن تقسيم تكوين الشعيبة الذي يتراوح سمكه بين 180 و 195 مترًا تقريبًا ، إلى ثلاث وحدات ليثولوجية: وحدة عليا (أ ، 8-15 م) تتكون من حجر جيري مبلور جزئيًا ؛ وحدة متوسطة (ب ، 52-56 م) وهي مكونة من الحجر الجيري الدولوميتي ؛ والوحدة السفلية (C ،> 110 متر سمكًا) التي تتكون من أحجار جيرية غنية بالصخر الزيتي والدولوميتية .. تشير النتائج إلى أن متوسط مقاومة الماء للتكوين (Rw = 0.021) ، ومقاومة متوسط راشح الطين (Rmf = 0.57) ، ومعلمات Archie تحديد من طريقة بكت بلوت (م = 1.94 ، ن = 2 ، و = 1). بينما تم حساب قيم المسامية وتشبع الماء مع عمق التكوين باستخدام برنامج تفاعل البتروفيزياء (IP V3.5). يوضح تفسير عملية الكمبيوتر (CPI) أن النتائج تشير إلى أن أفضل منطقة مسامية تحصن أعلى نسبة مئوية من الهيدروكربون المتحرك في الشعيبة يركز الخزان في المنطقة الثانية. ER -