TY - JOUR ID - TI - Strengthening of RC Beam with Large Square Opening Using CFRP تقوية العتبات الخرسانيةالمسلحة الحاوية على فتحات lمربعة كبيرة في فضاءاتها بااستعمال ألياف التسليح كاربون- بوليمر AU - Aya w.Naqe اية وليد نقي AU - Alaa H. Al-zuhairi علاء حسين الزهيري PY - 2020 VL - 26 IS - 10 SP - 123 EP - 134 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - The use of essential services in modern constructions, such pipes, and ducts, became important, placing these pipes and ducts underneath the soffit of the beam. They made a ceiling sandwich, and that causes to reduce the height of the floor, so the presence of the opening in the beam saves the height of the floor. In this paper, the investigation of the beam response of reinforced concrete simply supported rectangle beams with square web openings is presented, including a number of the web openings (two, four, and eight), in addition to its use in strengthening the member at the openings (when the beam is planned before casting, internal deformation steel bar is used, and in case of the opening is existing in the beam, (CFRP) fabric is used.). The test results indicated that the opening Strengthening of beams might compensate for the decrease of the beam load capacity because of the existence of the openings in the shear zone. The compensation of beam capacity depends on the strengthening method, which was adopted. The shear crack loads of the strengthened with externally CFRP specimen's reduction ranging from (15.38 to 38.46%) of their failure loads while the shear crack load of internally reinforced strengthened ranging from (15.38 to 30.76%).

استخدام الخدمات الأساسية في الإنشاءات الحديثة ، تصبح هذه الأنابيب والأنابيب مهمة في وضع هذه الأنابيب والقنوات تحت فتحة الشعاع وصنع شطيرة في السقف وتؤدي إلى تقليل ارتفاع الأرضية وبالتالي يحفظ وجود الفتحة في الشعاع ارتفاع الأرض. في هذه الورقة ، تم تقديم دراسة عن استجابة الشعاع للخرسانة المسلحة عوارض المستطيل المدعومة ببساطة مع فتحات شبكة مربعة. بما في ذلك عدد فتحات الويب (اثنان ، أربعة وثمانية) والاستخدام في تقوية العضو في الفتحات (عندما يتم تخطيط الحزمة قبل الصب ، في هذه الحالة ، استخدم قضيب فولاذي داخلي للتشوه وفي حالة وجود فتحة في شعاع استخدام (CFRP) النسيج.). أشارت نتائج الاختبار إلى أن تقوية فتح الحزم قد تعوض عن انخفاض سعة تحميل الحزمة بسبب وجود الفتحات في منطقة القص. يعتمد تعويض قدرة الحزمة على طريقة التعزيز التي تم اعتمادها. أحمال صدع القص في المقوى مع انخفاض عينة CFRP خارجيًا تتراوح بين (15.38 إلى 38.46٪) من أحمال عطلها ، في حين أن حمولة صدع القص من المقواة داخليًا تتراوح من (15.38 إلى 30.76٪). ER -