TY - JOUR ID - TI - An Efficient Grid-tied Flyback Micro-inverter with DCM Control Strategy عاكس فلايباك صغير و كفوء مرتبط للشبكة مع سيطرةاستراتيجية التحكم في وضع التوصيل المتقطع (DCM) AU - Adel A. Obed عادل احمد عبيد AU - Salam J. Yaqoob سلام جبر يعقوب PY - 2021 VL - 3 IS - 1 SP - E74 EP - E84 JO - Journal of Techniques مجلة التقني SN - 27088383 AB - In two-stage micro-inverter photovoltaic (PV) applications, DC/DC converter is used to obtain the highest DC power from the PV module. In this type of inverter, the rising of voltage from the PV module to a grid voltage level is limited to a certain value. Moreover, the absence of the isolation between the input and output makes it is less efficient. For these reasons, an efficient single-stage grid-tied flyback PV micro-inverter with discontinuous conduction mode (DCM) control strategy is proposed to feed an alternating current (AC) to the main grid with a lower value of the total harmonic distortion (THD). The control strategy is based on a sine sinusoidal pulse width modulation (SPWM) technique to control the main switch of flyback inverter. Also, a simple perturb and observe (P&O) maximum power point tracking (MPPT) technique has been presented to obtain the MPP point from the PV module for any environmental conditions. The proposed control was verified using PSIM software and simulation results is obtained. The proposed control is tested under different weather conditions for solar irradiance and temperature, as a result, a pure sin wave current has been injected into the grid with a lower harmonics value. Finally, the small size, low cost and high reliability of single stage flyback micro-inverter is presented without the need for DC/DC converter.

في تطبيقات الخلايا الكهروضوئية ذات المرحلتين الدقيقة (PV) ، يتم استخدام محول DC / DC للحصول على أعلى طاقة تيار مستمر من الوحدة الكهروضوئية. في هذا النوع من العاكس ، يقتصر ارتفاع الجهد من الوحدة الكهروضوئية إلى مستوى جهد الشبكة على قيمة معينة. علاوة على ذلك ، فإن عدم وجود عزل بين المدخلات والمخرجات يجعلها أقل كفاءة. لهذه الأسباب ، يُقترح العاكس الجزئي الكهروضوئي عالي الكفاءة ذو المرحلة الواحدة المرتبط بالشبكة مع إستراتيجية التحكم في وضع التوصيل المتقطع (DCM) لتغذية تيار متناوب (AC) إلى الشبكة الرئيسية بقيمة أقل من إجمالي التشويه التوافقي ( THD). تعتمد استراتيجية التحكم على تقنية تعديل عرض النبضة الجيبية (SPWM) للتحكم في المفتاح الرئيسي لعاكس flyback. أيضًا ، تم تقديم أسلوب بسيط للاضطراب والمراقبة (P&O) لتتبع نقطة الطاقة القصوى (MPPT) للحصول على نقطة MPP من الوحدة الكهروضوئية لأي ظروف بيئية. تم التحقق من عنصر التحكم المقترح باستخدام برنامج PSIM وتم الحصول على نتائج المحاكاة. يتم اختبار التحكم المقترح في ظل ظروف جوية مختلفة للإشعاع الشمسي ودرجة الحرارة ، ونتيجة لذلك ، تم حقن تيار موجة خطيئة نقية في الشبكة بقيمة توافقية منخفضة. أخيرًا ، يتم تقديم الحجم الصغير والتكلفة المنخفضة والموثوقية العالية للعاكس الصغير flyback بمرحلة واحدة دون الحاجة إلى محول DC / DC ER -