@Article{, title={Flash Evaporation Enhancement By Electrolysis Of Saturated Water Flowing Upwards In Vertical Pipe}, author={Radwan Muhammad Addaiy and Akram. W. Izzat}, journal={Journal of Engineering مجلة الهندسة}, volume={16}, number={3}, pages={5620 -5632}, year={2010}, abstract={An experimental system was designed and built to produce the flash evaporation of upward water flow in a (1.8 m) vertical mounted glass test section pipe. The water loses the static head as it moves up, accordingly flash evaporation occurs somewhere inside the test section, where the water local temperature reaches its saturation temperature at that position, which is dependent on the water inlet temperature and its mass flow rate. The steam quality in the test section exit was measured by collecting the steam generated in the test section outlet and condensed in the condenser at specified time. The hydrogen bubbles are injected inside the two – phase mixture flow within the test section. These bubbles act as an exciter for steam generation inside saturated water. Water electrolysis using (12 V) and ionization current (7 A), increases steam quality at test section outlet by (33%) when it is compared to that obtained without water electrolysis. A reduction of (42%) in non-equilibrium temperature difference is achieved using the same ionization settings. The effect of ionization process on flash inception point and temperature is investigated from the experiments. The experimental results are compared to the theoretical results obtained using mathematical model based on solving the mass, momentum and energy equations for two –phase flow assuming separated flow model. The effect of the electrical power used for water ionization is simply simulated in these calculations using mass and heat balance equation that covers the boundary conditions of the system.

تم تصميم منظومة تجريبية لغرض تحقيق ظاهرة الغليان التلقائي أثناء جريان الماء إلى الأعلى داخل أنبوب زجاجي بطول (1,8 م ) مخصص للقياسات , عمودي التثبيت . عند جريان الماء إلى الأعلى فانه يفقد جزءا من ضغطه الاستاتيكي , عند ذلك يحصل الغليان التلقائي عند نقطة ما داخل الأنبوب الزجاجي تكون فيها درجة حرارة الماء مساوية لدرجة حرارة الإشباع في تلك النقطة . تم قياس النسبة الوزنية للبخار ( steam quality ) في مخرج الأنبوب الزجاجي من خلال تجميع البخار المتولد في الأنبوب الزجاجي والمتكثف في جهاز التكثيف خلال فترة زمنية محددة . لقد تم حقن فقاعات الهيدروجين في داخل المزيج الثنائي الطور أثناء جريانه في الأنبوب الزجاجي. حيث تعمل فقاعات الهيدروجين كمحفز لتوليد البخار . لقد وجد إن نسبة البخار الوزنية (steam quality ) عند نهاية انبوبة الاختيار تزداد بنسبة ( 33 %) عما عليه بدون حقن تلك الفقاعات وذلك بتسليط فرق جهد قدره 12 فولت وتيار قيمته 7 أمبير, وانخفاض بنسبة (42%) من قيمة درجة الحرارة غير المتزنة عند نفس ظروف التأيين. إن تأثير عملية التائيين على نقطة بداية الغليان التلقائي ودرجة حرارته تم دراستها خلال الجزء العملي . النتائج العملية تم مقارنتها مع النتائج النظرية والتي حصلنا عليها باستخدام موديل رياضي يستند في حله على معادلات الكتلة والزخم والطاقة لجريان ثنائي الطور مع فرض نمط جريان أنفصال عند الحل . إن تأثير الطاقة الكهربائية المستخدمة في عملية التائيين يكون مبسطا في عمليات الحساب باستخدام معادلة توازن الكتلة والحرارة والتي تغطي الظروف المحيطة بالمنظومة.} }