TY - JOUR ID - TI - Design of a Percolator for Aqua-Ammonia Liquid AU - Ali S. Baqir AU - Mikdam M. Saleh PY - 2005 VL - 11 IS - 1 SP - 33 EP - 49 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - A new design concept for a percolator is developed which combine the simultaneous production of ammonia vapor plus the pumping of weak aqua ammonia liquid. This steady state design was based on a balance between the hydrostatic driving head and the total signal and two-phase pressure losses in the percolator system. To accomplish this, the results from modeling of the driving pressure and pressure losses, using the separated flow and drift flux methods were compared with the experimental measurements. The Chisholm’s model was the best in predicting the measured flow rate versus water level for first stage with a maximum standard deviation of ± 10.1 % and was adopted for the theoretical calculations. Parametric design studies that include the cooling power and the strong solution level, inner tube diameter and height for each stage of the percolator were carried out to maximize suitable cost function. The results of the optimization gave a two stage percolator of length 280 mm, inner diameter 5.5 mm for first stage and length 520 mm, inner diameter 5.5 mm for second stage.

تم تطوير فكرة تصميم جديد لمبخر نفاث والذي يجمع بين انتاج بخار الامونيا وعملية الضخ لسائل امونيا ضعيف التركيز. ان تصميم الحالة الثابتة قام على اساس التوازن بين القوة الدافعة الهيدروستاتية وبين فقدان الضغط الناجم عن الجريان الاحادي والثنائي الطور في نظام المبخر. لغرض اتمام ذلك فان النتائج المستحصلة من عملية تمثيل للضغط الدافع وكذلك فقدان الضغط باستخدام الجريان المنفصل والجريان المنبثق الانحرافي تم مقارنة الحسابات النظرية بالقياسات العملية ياستخدام الماء كسائل العمل. لتحديد الموديل المناسب لفقدان الضغط تبين ان (موديل جزم ) يعتبر الافضل في التنبؤ بقياسات معدل الجريان مقابل مستوى الماء بالنسبة للمرحلة الاولى حيث ان الانحراف المعياري كان ± 10.1 % . ان استخدام التصميم البارامتري ( الذي يشمل على طاقة التبريد ، مستوى المحلول القوي، قطر الانبوب الداخلي وارتفاع كل مرحلة بالنسبة للمبخر) توصل الى ايجاد الابعاد المثلى للمبخر والمتمثلة بمبخر ذو مرحلتين بطول 280 ملم وبقطر 5.5 ملم بالنسبة للمرحلة الاولىوبطول قدره 520 ملم وقطر داخلي 5.5 ملم بالنسبة للمرحلة الثانية. ER -