TY - JOUR ID - TI - Study The Effect Of The (Al) And (Al2O3) Particles Reinforcing On The Wear Volume Loss Characteristics Of Epoxy دراسة تأثیر التقویة بدقائق (Al) و (Al2O3) على خصائص خسارة حجم البلى للأیبوكسي AU - Bassam Ali Ahmed AU - Jamal Jalal Dawood PY - 2009 VL - 27 IS - 1 SP - 116 EP - 126 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - This study investigated experimentally the wear volume loss of the epoxy reinforcedby (Al) and (Al2O3) particles of grain size ( £ 30 mm) with different four volumefractions of the reinforcements which are (3 %, 6 %, 9 %, and 12 % Vol.). Pin-on-Discwear test were conducted to exam the wear volume loss behavior of the compositespecimens. The wear test results indicated that the wear volume loss of the specimenincreases with the increase of the applied load and sliding time, while it decreases withthe increase of the volume fraction of the reinforcing material. Also the results show thatthe average volume loss of the epoxy reinforced by (Al) was higher than reinforced by(Al2O3) by the value was (45 % ) at volume fraction (= 6 %), sliding speed (Vs =2m/sec.) and sliding time ( T =300 sec.)

ذات الحجم (Al2O و ( 3 (Al) هذه الدراسة بحثت عمليا" خسارة حجم البلى للأيبوكسي المقوى بدقائق.(12 %, 9%, 6 %, 30 ) عند أربعة كسور حجميه مختلفة لمادة التقوية (% 3 mm ³) الحبيبيأستخدم جهاز البلى نوع ( مسمار – على – قرص ) للتوصل إلى طبيعة خسارة حجم البلى للعيناتالمتراكبة المستخدمة. بينت النتائج بان خسارة الحجم للعينات تزداد مع زيادة الحمل المسلط وزمن الانزلاق بينماتقل مع زيادة الكسر ألحجمي لمادة التقوية. كذلك بينت النتائج بان معدل خسارة حجم البلى للأيبوكسي المقوى ب(2 m/sec.) بنسبة (% 45 ) عند كسر حجمي (% 6) وسرعة أنزلاق (Al2O أعلى من المقوى ب ( 3 (Al).(300 sec.) وزمن أنزلاق ER -