TY - JOUR ID - TI - FIELD ADJUSTMENT FOR CONCRETE MIXES IN ACCORDANCE WITH MOISTURE CONDITIONS OF AGGREGATES تعديل اوزان مكونات الخلطات الخرسانية في مواقع العمل نسبة الى حالة الركام من حيث محتو ى الرطوبة AU - Ali hussain Ali AU - Nadwa Sadi Hassan AU - Mohammed Yasin Hammed PY - 2011 VL - 24 IS - 8 SP - E39 EP - E53 JO - Journal of Techniques مجلة التقني SN - 27088383 AB - American Concrete Institute (ACI) mix design method, was used to calculate the quantities of the constituents (cement, water, sand, and gravel) of a specific Non-air-entrained concrete of a specified workability and compressive strength. These quantities are calculated on the basis that the aggregates were in the saturated-surface dry (S.S.D.) condition. Aggregates in the S.S.D. condition can be prepared and controlled in the laboratory, but in the field, it is difficult and impossible to gain it. Therefore, nine probabilities of moisture conditions of the aggregates will be arise in the site works (at the mixer), and, in order to overcome this problems, field adjustment with relation to moisture condition of aggregates must be done when the concrete compounds were put in the mixer. Experimental work shows that, the 7 and 28 days compressive strengths are (27.10) and (38.74) MPa respectively using the mix proportions of the reference mix designed by the ACI method and the S.S.D. aggregates. Good results (an average value of 35.80 MPa) are obtained using the nine probable cases of moisture condition other than the S.S.D. All the adjusted mix proportions can be used practically and successfully, and their values are acceptable comparing with the 28-day characteristic strength (34.00) MPa of the reference mix obtained using the ACI method. Finally, empirical expressions are derived to calculate the adjusted quantities of concrete constituents for the nine probable cases of moisture conditions

تم اتباع طريقة معهد الخرسانة الامريكي (ACI) لتصميم الخلطات الخرسانية في حساب كميات المكونات (السمنت ، الماء ، الرمل ، والحصى) الداخلة في انتاج خلطة خرسانية (غير مهواة) ذات خواص نوعية من قابلية التشغيل ومقاومة الانضغاط. ان هذه المكونات تم حسابها على اساس ان الركام المستخدم (الرمل والحصى) يكون في حالة المشبع-الجاف السطح (S.S.D.) ، وان هذا النوع من الركام بالامكان تهيأته واستعماله والسيطرة عليه مختبريا ، الا انه في موقع العمل والصب يكون من الصعب بل من المستحيل الحصول على هذا النوع من الركام. لذلك ، ظهرت تسعة احتمالات لتواجد الركام في مواقع العمل نسبة الى محتواه للرطوبة ، ولاجل علاج هذه المشكلة الموقعية يجب اجراء التعديلات اللازمة على اوزان المواد الداخلة في الخرسانة نسبة الى وضع الركام من حيث الرطوبة السطحية وقابلية الامتصاص ، ويطلق على هذه العملية تعديل الوجبات (Field Adjustment). النتائج العملية بينت بان مقاومة الخرسانة بعمر (7 و 28) يوم كانت (27.10) و (38.74) نيوتن/ملم2 على التوالي وتم الحصول عليها باستخدام نسب المزج للخلطة المرجعية باتباع طريقة (ACI) لتصميم الخلطات الخرسانية والركام في حالة ال (S.S.D.). تم الحصول على نتائج جيدة (معدل مقاومة الانضغاط 35.80 نيوتن/ملم2) باستعمال الاحتمالات التسعة لحالة الركام من حيث محتواه للرطوبة ما عدا حالة الركام المشبع وجاف السطح. لذلك ، فبالامكان استخدام كافة نسب المزج المعدلة بشكل عملي وناجح ، ونتائج هذه الحالات التسعة مقبولة مقارنة مع مقاومة الانضغاط المرجعية والتي قيمتها 34.00 نيوتن/ملم2 والمستحصلة باتباع طريقة (ACI) لتصميم الخلطات الخرسانية. اخيرا ، فقد تم اشتقاق علاقات رياضية تستعمل لحساب كميات المواد المعدلة للاحتمالات التسعة الخاصة بحالة الركام وفقا لمحتواه للرطوبة. ER -