TY - JOUR ID - TI - دراسة بعض الخواص الفيزيائية لمتراكبات بوليمرية المستخدمة في بيئة كيمياوية سلبية AU - رولا عبد الخضر عباس PY - 2010 VL - 13 IS - 3 SP - 1 EP - 20 JO - Al-Nahrain Journal of Science مجلة النهرين للعلوم SN - 26635453 26635461 AB - Study was a reflection of the impact of theextensive use of overlapping materialspolymer composed of material of glass fiberreinforced epoxy in the center of bothcontaminated with chemicals (acid and base)on the physical properties, which included(Hardness, resistance to compressionCompressive Strength, compressiondeformation and deformation Compressive,and absorbed the maximum amount of acidsolution or basal M∞, and diffuse (Diffusivity)D), as evidence of the importance of chemicalsas one of the sources of pollution whichcontribute directly or indirectly in the processof aging of these materials overlapped. And itwas also to examine the factors accelerated theprocess of chemical aging here (chemicalnature and concentration, as well astemperature and immersion time of it) andhow these impact on the efficiency ofaccelerators functioning with accumulation inthe composite body prepared. Note that thearticle supported Overlapping prepared anumber of plywood sheets authority matchopped glass fiber (chopped mat strand) andthe (6,8,10,12) layer for composite materialsdifferent volumetric fraction of fiberreinforcement ranged between (53.3-20%),and the solution pH elected for this study wereacetic acid and a potassium hydroxide, whichranged between standard (2-0.5N), or a greaterconcentration of potassium hydroxide byweight up to about (10.2-2.8%), while equivalent to increasing the concentration ofacetic acid per volume of up to about (15-3.757%). The comparison results showed thatincreasing the concentration of the chemicalquality of the center (acid and base), andtemperature, which ranged between (14 to60)0C in addition to the time of immersion,and not more than (34) hours, all of whichhave a negative impact on the hardness andresistance to compression, Because thesecommunities as they enter the body polymercomposite accumulate year after year to beharmful to focus composite materials andproperties caused by the overlapping agingmaterials prepared and it seems clear from theincrease in assessed compression deformationand the amount of swelling maximum. Theresearch also found the results are obvious andclear that it could delay the process ofincreasing the number of layers of limitationfiberglass reinforced epoxy material whichaccompanied the process of delay does notappear to unforeseen damage to the third eyein the article is strikingly overlapped with thevolumetric fraction (29%) compared with themodel is the volumetric fraction (20%) whenplaced in a standard acid solution (2N) andtemperature (140C). Accordingly, use ofphotography to document these macroscopicdamage observed in the article overlappedwith the volumetric fraction (20%), whileensuring that the optical microscopy imagingto monitor the damage was not seen by thenaked eye with the film surfaces and the partsaffected side and the article generated in theoverlapped with the volumetric fraction (29 %).The result of the extensive use of overlappingin the center base to accelerate the process isfaster than aging medium acid.

تم دراسة انعكاس تأثير الاستخدام المسهب لمواد متراكبة بوليمرية مكونة من مادة الايبوكسي المقواة بألياف الزجاج فيمقاومة Hardness وسط ملوث بمواد كيميائية بنوعيها (ألحامضي والقاعدي) على خواصها الفيزيائية والتي شملت (الصلادةوأقصى كمية ممتصة من محلول ،Compressive deformation وتشوه الانضغاط ،Compressive Sterngh الانضغاطباعتبار ثبوت أهمية المواد الكيميائية كأحد مصادر التلوث التي ،((Diffusivity) D و الانتشارية M∞ ألحامضي أو القاعديتساهم بطريقة مباشرة أو غير مباشرة في عملية تقادم هذه المواد المتراكبة. تم أيضاً دراسة العوامل المعجلة بعملية التعتيقالكيميائي والمتمثلة هنا ب (طبيعة وتركيزالوسط الكيميائي، فضلاً عن درجة حرارته وزمن الغمر فيه) وكيفية تأثير هذهالمعجلات على كفاءة الأداء الوظيفي مع تراكمها في جسم المتراكبات المحضرة.علماً بان المادة المتراكبة المحضرة دعمت بعدد من الصفائح الرقائقية بهيئة حصيرة من ألياف زجاجية مقطعةوالتي عددها ( 12 ،10 ،8 ،6 ) طبقة للحصول على متراكبات مختلفة في الكسر ألحجمي لألياف (Chopped strand mat)53.3 %)، أما المحاليل الحامضية والقاعدية المنتخبة لهذه الدراسة عبارة عن حامض - التدعيم بنسبة تراوحت مابين ( 202-0.5 ) بما يعادل زيادة تركيز قاعدة N) الاسيتيك (الخليك) وقاعدة هيدروكسيد البوتاسيوم، ذات عياريه تراوحت بين10.2 %) في حين يعادل زيادة تركيز حامض الخليك بنسبة حجمية - هيدروكسيد البوتاسيوم بنسبة وزنيه تصل إلى نحو ( 2.8.(%15- تصل إلى نحو ( 3.757لقد أظهرت النتائج المقارنة بأن زيادة تركيز الوسط الكيميائي بنوعية (ألحامضي و القاعدي) ودرجة حرارته التي تراوحتبين ( 14 إلى 60 ) درجة مئوية علاوة على زمن التغطيس فيه والذي لا يزيد عن ( 34 ) ساعة يؤثر كل منها بشكل سلبي علىالصلادة ومقاومة الانضغاط، نظراً لأن هذه الأوساط عند دخولها في جسم المتراكب البوليمري تتراكم عاماً بعد عام إلى أنتصل إلى التركيز الضار بخواص المتراكب والذي يتسبب عنه تعتيق المواد المتراكبة المحضرة ويبدو ذلك واضحاً من زيادة.(Maximum amount ،swelling M∞) قيمت تشوه الانضغاط وكمية الانتفاخ القصوىكما خلص البحث أيضا إلى نتائج واضحة وجلية وهو أنه يمكن تأخير عملية التقادم بزيادة عدد طبقات الألياف الزجاجيةالمدعمة لمادة الايبوكسي حيث صحب عملية التأخير عدم ظهور الأضرار الغير المنظورة للعين المجردة بشكل ملفت في المادةالمتراكبة ذات الكسر الحجمي (% 29 ) بالمقارنة بالنموذج ذو الكسر ألحجمي (% 20 ) عند غمرها في المحلول الحامضي ذو14 ). وعليه تم الاستفادة من التصوير الفوتوغرافي لتوثيق هذه الإضرار العيانية الملاحظة 0C) 2) وبدرجة حرارة N) عياريةفي المادة المتراكبة ذات الكسر ألحجمي (% 20 )، بينما يكفل التصوير بالمجهر الضوئي رصد الأضرار التي لم ترى بالعين.( المجردة مع تصوير السطوح المتضررة والأجزاء الجانبية منها والمتولدة في المادة المتراكبة ذات الكسر ألحجمي (% 29كما يؤدي الاستخدام المسهب للمادة المتراكبة في الوسط القاعدي بالتعجيل بعملية تعتيقها بشكل أسرع بالمقارنة بالوسطألحامضي ER -