TY - JOUR ID - TI - WELDING OF THERMOPLASTIC MATERIALS USING CO2 LASER لحیم البلاستك الح ا رري باستخدام لیزر ثنائي اوكسید الكربون ( CO2) AU - Fayroz A. Sabah فیروز عارف صباح AU - Sanaa N. Mohammed سناء نعمان محمد PY - 2012 VL - 5 IS - 1 SP - 40 EP - 51 JO - DIYALA JOURNAL OF ENGINEERING SCIENCES مجلة ديالى للعلوم الهندسية SN - 19998716 26166909 AB - ABSTRACT:- The welding of thermoplastics using CO2 laser achieved, two different types of thermoplastic materials used which are; Perspex (PMMA) which is the abbreviation of polymethyl methacrylate and (HDPE) which is the abbreviation of high density polyethylene. Similar or different materials can be welded together by laser beam but in thiswork similar polymers have been welded (i.e PMMA tube to PMMA tube and HDPE plate to HDPE plate). Mechanical properties for these materials measured after welding, two CW CO2 lasers were used in the welding process have the wavelength of 10.6μm. The maximum power of the 1st one is 16W, and for the 2nd one is 25W. The experimental result showed thatthe penetration depth increases with increasing laser output when the welding speed is constant. Also a relation between spot width and depth calculated using MATLAB software program version 6.5 taken into account the effect of the following parameters, power used in welding, melting temperature of the materials, welding speed and the spot diameter of thelaser beam.Keywords: CO2, HDPE, PMMA, MATLAB software, power, welding.

الخلاصةPerspex ; لیزر، تم استخدام نوعین مختلفین من البلاستك CO تم لحام المواد البلاستك باستخدام 2 وهو اختصارا ل بولي اثیلین عالي الكثافة. (HDPE) و polymethyl methacrylate وهو اختصارا ل (PMMA) یمكن لحام مواد متشابهه او مختلفة بواسطة شعاع اللیزر لكن في هذا العمل تم لحام مواد بولیمر متشابهه. المواصفات 10.6 ، اقصى قدرة للجهاز μm لیزر بطول موجي CO المیكانیكیة لهذه المواد قیست بعد عملیة اللحام، استخدم جهازي 2 25 . عمق الاختراق یزداد بزیادة قوة شعاع اللیزر عند ثبوت سرعة اللحام. كذلك العلاقة بین W 16 وللثاني W الاو ل ال ٦.٥ بالاعتماد على القدرة المستخدمة في اللحام، MATLAB عرض البقعة والعمق حسبت ووجدت باستخدام برنامج درجة حرارة ذوبان المواد المستخدمة، سرعة اللحام وقطر بقعة شعاع اللیزر. ER -