TY - JOUR ID - TI - The Effect of Adding Carbon (soot) to the Paint of an Absorbing Surface in Homemade Solar Systems تأثير إضافة الكربون على الطلاء للسطح الماص في المجمعات الشمسية الحرارية AU - Hala K. Saleh هالة قيدار محمد صالح PY - 2012 VL - 23 IS - 3E SP - 137 EP - 143 JO - Rafidain journal of science مجلة علوم الرافدين SN - 16089391 AB - Absorbing materials are key components of any solar water heater device. Silicon solar cells are very efficient but are highly expensive. An alternative is to use absorbing materials that are cheaper than silicon to produce. The use of carbon (soot) in the preparation of the coating layer of a homemade solar water heater has been investigated. When added in different proportions to oil-based white paint, marked increases in water temperatures were obtained. The increase in water temperature was directly proportional with the increase in the percentage of carbon in the coating layer. The maximum achieved outlet water temperature was 90° C in July and 70° C in November.Due to its non-toxic nature and very low cost, carbon in the form of smoke suspension or soot, can provide a good and reliable alternative in the fabrication of domestic solar water heaters.

تعد المواد الماصة جزءا مهما لأي نظام سخان حراري شمسي. تكون خلايا السليكا الشمسية ذات كفاءة عالية جدا لكنها مرتفعة الكلفة أيضا. إن البديل هو استخدام مواد ماصة أرخص كلفة من السليكا عند الإنتاج. إن استخدام الكربون في تحضير طبقة الطلاء لسخان ماء شمسي قد تم اختباره. فعندما يضاف الكربون بنسب مختلفة إلى طلاء زيتي أبيض، نحصل على درجة حرارة ماء مرتفعة. يتناسب ازدياد درجة حرارة الماء طرديا مع زيادة نسبة الكربون المضاف إلى طبقة الطلاء. كانت أعلى درجة حرارة للماء °90 سليزية في تموز و°70 سليزية في تشرين الثاني.وبالنظر إلى طبيعة الكربون غير السامة ورخص كلفته، فإنه يوفر بديلا جيدا يمكن اعتماده في عمل سخانات الماء الحرارية المحلية الصنع. ER -