@Article{, title={Effect of Prestressed CFRP Plate Location on Behavior of RC Beam Strengthened with Prestressed CFRP Plate}, author={Ali Jalil Chabuk and Mohammed Jassam Mohammed and Majid Mohammed Ali Kadhim}, journal={Journal of University of Babylon مجلة جامعة بابل}, volume={20}, number={1}, pages={105-113}, year={2012}, abstract={This paper presents an analytical model to study flexural behavior of reinforced concrete beams strengthened with prestressed carbon fiber reinforced polymer (CFRP) plate by using finite element software (ANSYS 11.0). Eight node brick element (SOLID65 as called in ANSYS) used to model reinforced concrete, four node shell element (SHELL41) used to model prestressed CFRP plate, and two node interface element (CONTAC52) used to model epoxy (bond between reinforced concrete and prestressed CFRP plate). Experimental data of two beams strengthened with prestressed CFRP plate were tested by (Xue et.al., 2010) are analyzed to check validating of FE model. An FE Parametric study was performed based on the above model is used to study the effect of prestressed CFRP plate locations, width , and thickness. Then find that used of prestressed CFRP plate on edges increased load carrying capacity of RC beam strengthened with prestressed CFRP plate about 11% than used in center of RC beam.

في هذا البحث تم استخدام نموذج تحليلي لدراسة سلوك الانحناء لعتب خرساني مسلح مقوى بصفائح البوليمر المسلحة بألياف الكاربون المسبقة الجهد وذلك باستخدام برنامج تحليل العناصر المحددة (ANSYS V11.0). وقد تم استخدام العناصر الطابوقية ذات ألثمان عقد (SOLID65 كما يطلق عليه ببرنامج ANSYS) لتمثيل الخرسانة المسلحة، وتم استخدام العناصر القشرية ذات الأربع عقد لتمثيل صفائح البوليمر المسلحة بألياف الكاربون المسبقة الجهد، وأخيرا تم استخدام العناصر البينية (CONTAC52) ذات العقدتين لتمثيل الرابط بين الخرسانة المساحة و صفائح البوليمر المسلحة بألياف الكاربون المسبقة الجهد. النتائج العملية لعتبان خرسانيان مقويان بصفائح البوليمر المسلحة بألياف الكاربون المسبقة الجهد والمفحوصة بواسطة (Xue et.al.) تم تحليلها للتأكد من جاهزية البرنامج. كذلك تم عمل دراسة لتقصي أفضل موقع وعرض وسمك صفائح البوليمر المسلحة بالألياف المسبقة الجهد. ووجدت نتائج الدراسة إن استخدام صفائح البوليمر المسلحة بالألياف المسبقة الجهد في حافات العتب تزيد من قابلية التحمل القصوى للعتب بمقدار لا يقل عن 11% من استخدام صفائح البوليمر المسلحة بالألياف المسبقة الجهد في مركز العتب.} }