TY - JOUR ID - TI - Shear Behavior of Self Compacting Concrete سلوك العتبات الخرسانية الذاتية الرص تحت تأثير أحمال القص AU - Ali F.Atshan علي فرحان عطشان PY - 2012 VL - 16 IS - 2 SP - 289 EP - 305 JO - Journal of Engineering and Sustainable Development (JEASD) مجلة الهندسة والتنمية المستدامة SN - 25200917 25200925 AB - Twelve self compacting concrete (SCC) beams were cast to investigate the shear behavior under two concentrated load. All beams have a constant longitudinal steel ratio of (0.02065) and constant gross section area of (17000)mm2. The tested beams were divided into two group with and without stirrups. The first group contained three beams without stirrup at different value of compressive strength ( ) with the same value of clear span to the effective depth ratio (ln/d), while the second group contained nine beams with stirrups. This group was divided into three series according to the compressive strength ( ) each series contained three beams at different value of clear span to effective depth ratio(ln/d).It was found that the ultimate shear strength predicated from ACI 318-08 is lesser than the experimental values. The ultimate shear strength for SCC beams with stirrups increase about 15.73%.30.69 %and 25.633 % when the compressive strength increased from (29.36 to 49.2 MPa) at clear span to effective ratio (ln/d) 6.164, 5.479 and 5.0 respectively. The ultimate shear strength for SCC beams without stirrups increased about 31.25% when the compressive strength increased from (29.36 to 49.2 MPa),the ultimate shear strength of SCC beams with stirrups increased about 29.966%,38.775%and 37.85% when the clear span to the effective depth (ln/d) decreased from (6.164 to 5.0) at compressive strength (fc) 29.36, 41.42 and 49.2 MPa respectively, the ultimate shear strength of SCC beams with stirrups increased about 85.41%, 68.96% and 63.492% as compared with ultimate shear strength without stirrups at compressive strength 29.36,41.42 and 49.2 MPa respectively

اثنتا عشر عتبة خرسانية ذاتية الرص صممت وفحصت تحت حملين مركزين . جميع العتبات تحوي عل نسبة حديد تسليح واحدة هي (0.02065) ومساحة المقطع العرضي هي (17000) ملم2.العتبات المفحوصة قسمت الى مجموعتين مجموعة مسلحة بحديد تسليح القص (الاتاري) والاخرى غير مسلحة بحديد تسليح القص (الاتاري).المجموعة الاولى تحوي على ثلاث عتبات خرسانية ذاتية الرص بدون حديد تسليح القص (الاتاري) بمقاومة انضغاط مختلفة بينما المجموعة الاخرى تحوي على تسعة عتبات خرسانية ذاتية الرص قسمت الى ثلاثة متواليات حسب مقاومة الانضغاط كل متاولية تحوي على ثلاث عتبات بنسب مختلفة من الطول الصافي الى العمق الفعال.بعد نتائج الفحص وجدت ان مقاومة القص القصوى المستحصلة من المدونة الامريكية (318M-08) اقل من النتائج المستحصلة من الجانب العملي, وان مقاومة القص للعتبات الخرسانية الحاوية على حديد تسليح الاتاري تزداد بمقدار 15.73% و 30.69% و 25.663% عند زيادة مقاومة الانضغاط من 29.2 نت/ ملم2 الى 49.2 نت/ ملم2 عند الطول الصافي الى العمق الفعال 6.164 و5.79 و5.00 على التوالي.ان مقاومة القص للعتبات الخرسانية الغير حاوية على حديد تسليح القص (الاتاري) تزداد بمقدار31.25 % عند زيادة مقاومة الانضغاط من (29.2) نت/ ملم2 الى (49.2) نت/ ملم2 , وان مقاومة القص للعتبات الخرسانية الذاتية الرص الحاوية على حديد تسليح تزداد بمقدار 22.966% و 38.775% 37.85% عند نقصان نسبة الطول الصافي الى العمق الفعال من (6.164 الى 5.0) بمقاومة انضغاط 29.36 نت/ ملم2 و41.42 نت/ ملم2 و49. نت/ ملم2 على التوالي.ان مقاومة القص للعتبات الخرسانية الحاوية على حديد تسليح القص(الاتاري) تزداد بمقدار85.41 % و 68.9% و 63.492% مقارنة مع العتبات الخرسانية الغير حاوية على حديد تسليح القص(الاتاري) عند مقاومة انضغاط 29.36نت/ ملم2 و41.42 نت/ ملم2 و49.2 نت/ ملم2 على التوالي. ER -