TY - JOUR ID - TI - DETERMINATION OF THE OPTIMAL SPRING- BACK PARAMETERS USING TAGUCHI METHOD ايجاد العوامل المثلى المؤثرة على الرجوعية باستخدام طريقة تاكوجي AU - Aseel Hamad Abed اسيل حمد عبد PY - 2013 VL - 6 IS - 1 SP - 53 EP - 61 JO - Al-Qadisiyah Journal for Engineering Sciences مجلة القادسية للعلوم الهندسية SN - 19984456 24117773 AB - Bending process is the one important process in the sheet metal forming in many industries, there are many parameters having a large effect on it. Spring- back is considered one of the most important indications to specify the quality of product parts. The objective of the present study is to find the optimum bending parameters to get lowest spring back on aluminum- silicon (Al- Si) alloy by applying the Taguchi method. The basic parameters which were taken into consideration in this work are: punch speed, hold time and the orientation of material in order. Experiments have been conducted by using L9 orthogonal array with three levels for each parameter. The bending process were done on Instron device ,the optimum combination of process parameters has been found through analysis of main effect of spring back value (αs) and Signal-to-Noise S/N ratio, and the significant parameter was identified depending on ANOVA analyses. In the present work to determine the level of importance of spring back parameters, the results show that the significant factor is the orientation of metal followed punch speed and hold time, and the obtained results from the experiments are acceptable for the ranges of forming conditions that have been selected in this case study.

تعتبر عملية الحني من العمليات التصنعية المهمة في تشكيل الصفائح حيث تتاثر بالعدجيد من العوامل. تعتبر الرجوعية من اهم الؤشرات لتهديد جودة ودقة المنتج. يهدف البحث الحالي الى ايجاد المتغيرات المثلى التي تحقق اقل ما يمكن من الرجوعية عند اجراء عملية الحني لاجزاء مصنعة من سبيكة الالمنيوم سليكون– بتطبيق طريقة تاكوجي . والمتغيرات التي تؤثر على الرجوعية التي اخذت بنظر الاعتبار هي سرعة التشكيل , زمن التوقف واتجاهية المعدن.اجريت التجارب باستخدام المصفوفة القياسية بواقع ثلاث مستويات من القيم لكل متغير. اجريتعملية الحني على جهاز (S/Nالانسترون واوجدت من هذه الدراسة المتغيرات المثالية من خلال تحليل معدل قيم الرجوعية ونسبة ( وكذلك بالاعتماد على تحليل التباين لتحديد درجة اهمية العوامل المؤثرة على الرجوعية , وجد ان لاتجاهية المعدن تاثيراً كبيرا على العملية يليه سرعة التشكيل ثم زمن التوقف وان النتائج المستحصلة من اجراء التجارب مقبولة لمديات ظروف التشكيل التي تم اختيارها. ER -