@Article{, title={Experimental Study for Shear Behavior of Hybrid Self-Compacting Concrete Beams دراسة عملية لسلوك القص في العتبات الخرسانية المسلحة المهجنة بخرسانة ذاتية الرص}, author={Ahmed Naji Delef احمد ناجي دلف and Husain Khalaf Jarallah حسين خلف جار الله and Mohammed Mosleh Salman محمد مصلح سلمان}, journal={Journal of Engineering and Sustainable Development (JEASD) مجلة الهندسة والتنمية المستدامة}, volume={17}, number={2}, pages={97-118}, year={2013}, abstract={This paper discusses shear behavior of hybrid reinforced concrete beams that consist of two different concrete layers: the tension layer is made of normal strength concrete with compressive strength of 25 MPa and the compression layer is made of self-compacting concrete with two values for compressive strength of 25 and 50 MPa. These hybrid beams have been compared with corresponding homogenous beams made with one type of concrete to assess their structural behavior. Fifteen simply supported beams have been used and distributed into five groups to investigate the effect of some important variables on the shear strength for each group, (the concrete compressive strengths and the tensile steel ratio). The hybrid beams failed in shear in similar linear behavior to the homogenous beams and the results show that, the ultimate average shear strength of the hybrid beams with self compacting concrete having a compressive strength of 50 MPa [ BHY(50)] is higher than the normal beams by 5.2 % and lower than the self compacting concrete beams having a compressive strength of 50 MPa [BSC(50)] by 12 % , while the ultimate average shear strength of the hybrid beams with normal strength self compacting concrete BHY(25) give approximately close shear strength values of normal beams. Also, from the results obtained, the shear strength of the hybrid beams BHY(50) and BHY(25) increase with the increase of the tensile steel ratio from 1.3 % to 1.94 % by 48 % and 53 % respectively compared to 51% for the normal strength beams. Some published shear strength equation where used for normal concrete have been used to predicate the shear strength values for hybrid concrete, finally these shear strength values have been compared with the shear strength results obtained from the experimental work presented in this paper in order to check the adequacy of using these equations in the shear strength calculation for hybrid concrete.

تم في هذا البحث دراسة سلوك القص في العتبات الخرسانية الإنشائية المهجنة والتي تتكون من طبقتين:الأولى مكونة من خرسانة اعتيادية (بمقاومة انضغاط مساوية إلى 25ميكاباسكال) في منطقة الشد والثانية من الخرسانة ذاتية الرص (بمقاومة انضغاط مساوية إلى 25 و 50 ميكاباسكال)في منطقة الانضغاط الهدف منها زيادة مقاومة القص للعتبات ذات الخرسانة الاعتيادية ومحاولة التعرف إلى السلوك الإنشائي لهذا النوع من العتبات ومقارنتها مع العتبات المتجانسة المكونة من نوع واحد من الخرسانة. تم عمل خمسة عشر عتبة خرسانية مسلحة بسيطة الإسناد موزعة على (5) مجاميع مختلفة .تم تحري تأثير بعض المتغيرات المهمة على مقاومة القص لكل مجموعة وهي كل من: مقاومة انضغاط الخرسانة ونسبة حديد التسليح الشد, وبعد فحص العتبات بطريقة ( one-point load ) لحين الفشل كان فشل العتبات المهجنة بشكل خطي مشابه للعتبات المتجانسة وقد أظهرت النتائج بان مقاومة القص للعتبات المهجنة بخرسانة ذاتية الرص عالية المقاومة BHY(50) كانت أعلى من مقاومة القص للعتبات ذات المقاومة الاعتيادية بنسبة ( 5.2%) واقل من مقاومة القص للعتبات المصنوعة من خرسانة ذاتية الرص عالية المقاومة BSC(50)بنسبة (12 % ) في حين كانت مقاومة القص للعتبات المهجنة بخرسانة ذاتية الرص ذات مقاومة اعتيادية( BHY(25 مقاربة لمقاومة القص للعتبات ذات المقاومة الاعتيادية. كذلك أظهرت النتائج بان مقاومة القص للعتبات المهجنة تزداد بزيادة نسبة حديد التسليح من 1.3% إلى 1.94% وكانت الزيادة في مقاومة القص هي ( 48 % ) للعتبات المهجنة بخرسانة ذاتية الرص عالية المقاومة BHY(50) و ( 53 % ) للعتبات المهجنة بخرسانة ذاتية الرص ذات مقاومة اعتيادية BHY(25) في حين كانت الزيادة في المقاومة للعتبات ذات المقاومة الاعتيادية هي (51%). أخيرا تم استخدام بعض المعادلات المنشورة سابقا الخاصة بمقاومة القص للخرسانة العادية في حساب مقاومة القص للعتبات ذات الخرسانة المهجنة وتمت مقارنة نتائج هذه المعادلات مع النتائج العملية لمعرفة دقة هذه المعادلات في حساب مقاومة القص للخرسانة المهجنة.} }