TY - JOUR ID - TI - Improvement of Soil by Using Polymer Fiber Materials Underneath Square Footing تحسين سلوك التربة بأستخدام الالياف البوليميرية تحت الاسس المربعة AU - HaiderMohammedMekkiyah حيدر محمد مكيه PY - 2013 VL - 19 IS - 7 SP - 873 EP - 882 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - The change in project cost, or cost growth, occurs from many factors, some of which are related to soil problem conditions that may occurs during construction and/or during site investigation period. This paper described a new soil improvement method with a minimum cost solution by using polymer fiber materials having a length of (3 cm) in both directions and (2.5 mm) in thickness, distributed in uniform medium dense sandy soil at different depths (B, 1.5B and 2B) below the footings. Three square footings has been used (5 ,7.5 and 10 cm) to carry the above investigation by using lever arm loading system design for such purposes. These fibers were distributed from depth of (0.1B) below the footing base down to the investigated depth. It was found that the initial vertical settlement of footing was highly affected in the early stage of loading due to complex Soil-Fiber Mixture (SFM) below the footing. The failure load value for proposed model in any case of loading increased compared with the un-reinforced soil by increasing the depth of improving below the footing. The Bearing Capacity Ratio (BCR) for soil-fiber mixture has been increased by ratio of (1.4 to 2.5), (1.7 to 4.9), and (1.8 to 8) for footings (5, 7.5, and 10 cm) respectively. The yield load-settlement for soil-fiber mixture system started at settlement of about 1.1% B while the yield load in un-reinforced soil started at smaller percentage which reflects the benefits of using such fiber materialfor improving soil behavior. Comparison between experimental and predicted (calculated) settlement below the footings showed the difference in ranges were within accepted limits for foundation settlements design.

أن التغير في كلف المشروع أو تنامي كلفه تحدث بسبب عوامل عديدة بعضا منها يعود لمشاكل التربة خلال فترة الانشاء أوفي مرحلة تحريات الموقع. الدراسة تقدم طريقة جديدة لتحسين تصرف التربة بأقل كلفة ممكنة بأستخدام الالياف البوليميرية (ذات الابعاد 3x3 cm وبسمك 2.5 mm) والالياف موزعة تحت اسس مربعة جالسة على رمل جاف متوسط الكثافة اختبرت لاعماق (B, 1.5B, 2B) . أن الاسس المربعة المستخدمة لاجراء هذه الدراسة كانت بابعاد(5, 7,10 cm) وباستخدام صندوق زجاج مقوى ونظام لذراع تحميل صمم لهذا الغرض . الالياف تم نشرها تحت الاسس بعمق يبدأ من ( 0.1B) تحت قاعدة الاساس ليصل الى العمق المطلوب للدراسة . نتائج الفحوص أظهرت بأن الهبوطات العمودية تحت هذه الاسس تأثرت في مراحل التحميل الاولية بسبب استخدام خليط التربة والالياف (SFM). تحسن قيم حمل الفشل لخليط التربة والالياف في الموديل ولاي حالة تحميل مقارنة مع التربة غير المسلحة. سعة التحمل لهذه الاسس(BCR) قد ازدادت بقيم (1.4-2.5)و (1.7-4.9) و 1.8-8)) لاسس (5, 7,10cm) على الترتيب. حمل الخضوع لخليط (SFM)يبدأ عند هبوط (1.1% B) في حين حمل الخضوع للتربة غير المسلحة يبدأ عند نسبا أقل وهذا يعكس الفائدة من استخدام هذه الالياف. أجريت مقارنة بين الهبوطات العملية وتلك المحسوبة وقد أظهرت النتائج تقاربا كبيرا بين القيم المقارنة. ER -