@Article{, title={The Effect of Elevated Temperature of Compressive Strength of Steel Fiber Concrete}, author={Osama M. Ghazi}, journal={Journal of University of Babylon مجلة جامعة بابل}, volume={21}, number={3}, pages={1006-1012}, year={2013}, abstract={This study presents the benefit gained from using steel fiber reinforcement on concrete mixture. The effect of fire on compressive strength is investigated. Two different tests, one of them is the non destructive test which is the ultrasonic pulse velocity (UPV) test and the other is the destructive compression test, are carried out using (10cm) cubes. Forty-eight cubes (half of them are with steel fiber reinforcement of fiber/concrete ratio of (0.01) by volume and the remaining cubes are without fiber reinforcement) are heated to temperature levels of (100,200,300,400,500,600 and 700°C). Then after that specimens are air cooled and (UPV) test is done, the specimens are destructively tested. The results indicated that the addition of steel fiber increases the compressive strength at all tested heating levels with a maximum percentage increase of (56.9%) at a temperature level of (500°C), in spite of that they have the same behavior but the residual compressive strength decreases with the addition of steel fiber for the tested heating levels lower than (400°C) and increases for the heating levels above this degree

الدراسة الحالية تسلط الضوء على الفائدة الحاصلة من تسليح الألياف الفولاذية في تكنولوجيا الخرسانة حيث بحث تاثير الحرارة على مقاومة انضغاطها.اجري نوعان من الفحص احدهما لااتلافي وهو فحص سرعة الأمواج فوق الصوتية (UPV)والأخر إتلافي باستعمال نماذج مكعبة بطول ضلع(10سم).تم تسخين(48) نموذج (نصفها مقواة بألياف الفولاذ بنسبة حجمية للالياف الفولاذية إلى الخرسانة مقدارها(0.01)والنماذج الأخرى المتبقية غير مقواة) إلى مستويات من درجات الحرارة هي(100و200و300و400و500و600و700)درجة سيليزية.فحصت النماذج لا اتلافيا بعد تبريدها بتعريضها للهواء ثم فحصت اتلافيا.بينت النتائج ان إضافة الألياف الفولاذية يزيد من مقاومة الانضغاط في كل مستويات درجات الحرارة التي قيست فيها باعلى نسبة زيادة مقدارها (56.9%) من تلك غير المقواة عند درجة حرارة (500) درجة سيليزية بالرغم من ان لهما نفس السلوك ولكن نسبة ما تبقى من المقاومة بعد الحرق من المقاومة الاصلية يقل باضافة الالياف الفولاذية عند كل مستويات درجات الحرارة الأقل من (400)درجة سيليزية ولكنها تزداد بعد تلك الدرجة.} }