@Article{, title={Mechanical Properties of Reactive Powder Concrete (RPC) with Mineral Admixture-ENG الخواص الميكانيكية لخرسانة المسحوق الفعالباستخدام مضافات معدنية}, author={Nuha H. Al-Jubory نهى حميدي الجبوري}, journal={AL-Rafidain Engineering Journal (AREJ) مجلة هندسة الرافدين}, volume={21}, number={5}, pages={92-101}, year={2013}, abstract={AbstractReactive powder concrete (RPC) is a special type of concrete, it is rather a mortar than an actual concrete mixture, because traditional coarse and fine aggregate are replaced by very fine sand with particle size in range of (150-400)µm. In the present experimental investigation, compressive strength, splitting tensile strength and flexural strength of plain reactive powder concrete and reactive powder concrete reinforced with 1% and 2% steel fiber are compared, by using local available material and curing in 20°C and 80°C, and the experimental study was curried out on a two sets of samples. Each set consisted of (54) cubes of (50×50×50mm), (18) cylinder of (100×200mm) and (18) prism of (50×50×300mm). The results show that the maximum compressive strength is 74 MPa with 2% steel fiber and curing in 20°C. The addition of steel fiber by 1% and 2%increased the compressive strength, splitting tensile strength and flexural strength.Keywords: reactive powder concrete, steel fibre, compressive strength, flexural strength, tensile strength

الخلاصةخرسانة المسحوق الفعال نوع خاص من الخرسانة اقرب ما يكون إلى عجينة السمنت لان الركام الخشن والناعم يستبدل بركام حجمه يتراوح بين (150-400)µmويتميز بأنه ذو مقاومة عالية جدا.في هذا البحث تم دراسة بعض خواص خرسانة المسحوق الفعال كمقاومة الانضغاط ومقاومة الشد الانشطاري ومقاومة الانثناءباستخدام مواد متوفرة محليا من سمنت وركام وسيليكا وملدن ودراسة تأثير تغير نسب الألياف الفولاذية وبظروف معالجة مختلفة بدرجة 20 و 80 درجة مئوية. الدراسة العمليةأجريت على مجموعة من النماذج لكل نوع من المعالجة شملت (54) مكعب بأبعاد (50×50×50mm), و(18) نموذج اسطواني بأبعاد (100×200mm), و (18) نموذج خرساني بأبعاد (50*50*300mm)وقد وجد أنأقصى مقاومة يمكن الحصول عليها باستخدام المواد المحلية ((74 MPa عند إضافة 2% ألياف فولاذية ومعالجة بدرجة 20 مئوية.} }