TY - JOUR ID - TI - Experimental Study on Effect of Changing Dr. Maha Abdul Ameer Kadhum Dr. Entidhar Mhawes Zghair Hayder Mohammed Hasan Welding Current on Mechanical and Metallurgical Properties of Seam Welding Joint for Low Carbon Steel AISI 1005 (0.8 mm) AU - Ammar Azeez Mahdi AL-Yasari PY - 2013 VL - 4 IS - 1 SP - 92 EP - 99 JO - University of Thi-Qar Journal for Engineering Sciences مجلة جامعة ذي قار للعلوم الهندسية SN - 26645564 26645572 AB - The aim of this work is to study the effect of changing welding current on the mechanical and metallurgical properties and choose the best welding current depend on result of study. The present work is an experimental study on effect of changing welding current on properties of seam welding joint for low carbon steel AISI 1005. Experiments results shows with increase welding current, hardness number will increase, also differentness in hardness number between weld nugget and HAZ (Heat Affected Zone) will increase and border of HAZ become bigger. Best mechanical results was achieved when welding current increased this doesn't mean that the highest current will become the suitable one, because the higher current will cause burin through in metal sheets and will cause leakage in products (liquid or gas storage tank), also will effect on grain size and microstructure due to changes in cooling rate, also the final shape of joints its important because most application of this type of weld is weight-goods industries (for civil using), so when use high welding current the final shape of joint will deform. Depended on above the best welding current rang is between 17 ≤ I < 19 K Amp.

يهدف البحث الى دراسة تاثير تغير تيار اللحام على الخواص الميكانيكية والميتالورجية لوصلات اللحام النقطي المستمر للحديد واطىء الكاربون, واختيار افضل تيار معتمداً على النتائج, حيث اظهرت النتائج العملية انه كلما زاد تيار اللحام زاد رقم الصلادة للملحومة وزادة مقاومة الشد اي تحسنت الخواص الميكانيكية ولاكن هذا لايعني ان افضل تيار يستخدم هو الأعلى قيمة لانه قد يؤدي الى انصهار بعض مناطق اللحام مما يؤدي العيب في المنتج لأن اغلب استخدامات هذا النوع من اللحام يكون في الخزانات, كما ان تطبيقات هذا اللحام تكون ظاهرة للعيان في اغلب التطبيقات المدنية لذلك يكون الشكل النهائي للمنتج ضروري وبناءاً على معطيات الخواص المجهرية والميكانيكية كما اوصت الجمعية الأمريكية للحام كانت افضل نتائج هي باستخدام تيار لحام يتراوح بين17 و19 كيلو امبير. ER -