TY - JOUR ID - TI - Simulation of a Wet Sulfuric Acid Process (WSA) for Utilization of Acid Gas Separated from Omani Natural Gas محاكاة لعملية أنتاج حامض الكبريتيك بالطريقة الرطبة (WSA) لاستغلال الغاز الحامضي المفصول من الغاز الطبيعي العماني AU - Ahmed Jawad Ali Al-Dallal احمد جواد علي PY - 2013 VL - 9 IS - 3 SP - 58 EP - 69 JO - Al-Khwarizmi Engineering Journal مجلة الخوارزمي الهندسية SN - 18181171 23120789 AB - In this study, a proposed process for the utilization of hydrogen sulphide separated with other gases from omani natural gas for the production of sulphuric acid by wet sulphuric acid process (WSA) was studied. The processwas simulated at an acid gas feed flow of 5000 m3/hr using Aspen ONE- V7.1-HYSYS software. A sensitivity analysis was conducted to determine the optimum conditions for the operation of plant. This included primarily the threepacked bed reactors connected in series for the production of sulphur trioxidewhich represented the bottleneck of the process. The optimum feed temperature and catalyst bed volume for each reactor were estimated and then used in the simulation of the whole process for two cases namely 4 and 6 mole% SO2 stream fed to the first catalytic reactor. The 4mole% SO2 gaves the highest conversion (98%) compared with 6 mole% SO2 (94.7%). A valuable quantity of heat was generated from the process. This excess heat could also be transformed into power in a turbine or used as a heating media in neighbouring process units.

في هذه البحث، تمت دراسة عملية مقترحة لاستغلال كبريتيد الهيدروجين المفصول مع غازات أخرى من الغاز الطبيعي العماني لإنتاج حامض الكبريتيك بالطريقة الرطبة (WSA) . تم محاكات هذه العملية عند تدفق حجمي للغاز الحامضي بحدود 5000 m3/h باستخدام برنامج .AspenONE- V7.1- HYSYS . تم كذلك اجراء تحليل الحساسية لتحديد الظروف المثلى لتشغيل المصنع. وهذا يشمل في المقام الأول المفاعلات الثلاثة المحملة بالعامل المحفز والمربوطة على التوالي لإنتاج ثالث أكسيد الكبريت التي تمثل عنق الزجاجة بالنسبة للعملية. تم التوصل الى درجة الحرارة المثلى لتلقيم كل مفاعل على حدة وكذلك تحديد كمية العامل المحفز لكل المفاعل حيث تم أستخدامها لاحقا في محاكاة العملية برمتها لحالتين هما 4 & 6 mole% SO2 كتيار تغذية للمفاعل الأول. 4% SO2 أعطى أعلى نسبة تحول 89 ) ٪ ( مقارنة مع (94.7%) 6% SO2 تم توليد كمية معتبرة من الحرارة نتيجة للعمليات داخل الوحدة. ويمكن أيضا تحويل هذه الحرارة الزائدة الى طاقة داخل توربينات أو يمكن استخدامها في عمليات التسخين لوحدات مجاورة . ER -