TY - JOUR ID - TI - EXPERIMENTAL STUDY FOR ENERGY DISSIPATION USING STILLING BASIN WITH ONE AND TWO CONSECUTIVE DROPS دراسة مختبرية لتشتيت الطاقة باستخدام احواض التهدئة احادية وثنائية المهابط AU - Qassem H. Jalut قاسم حميد جلعوط AU - Nagla F. El-Baaja نجلة فرج البعجة PY - 2014 VL - 7 IS - 2 SP - 61 EP - 82 JO - DIYALA JOURNAL OF ENGINEERING SCIENCES مجلة ديالى للعلوم الهندسية SN - 19998716 26166909 AB - The scour at downstream of hydraulic structures is one of the major concern in its stability analysis and operation .The excess energy existing immediately downstream of such structures has to be controlled. Hence, it is necessary to design and install a device for dissipating excess energy in order to prevent downstream scour. The drop structures is one of the commonly structures used for dissipating excess energy. In the present study an experimental approach is employed through which different types of stilling basin with different heights were tested using one drop and two consecutive drops. Moreover the effect of the end sill and baffles with different heights and different bed slopes was investigated. The hydraulic parameters involved were measured experimentally using a model of straight drop installed in the available (S6) multi-purpose flume in the fluid mechanics lab at the Civil Engineering Department, University of Garyounis.Results showed that, for one drop the presence of end sill reduced the length of the jump by a small value approximately 4%with an increase of relative energy loss by a small value. The increase of relative baffles block height increases the optimum relative height of drop (w/y1=6), and the relative energy loss .For two consecutive drops it was found that the most value of energy loss takes place in the second basin. The presences of end sill at the end of second basin increases the performance of second basin by small value approximately 5%. It is also shown that increasing the relative height of baffles blocks lead to increases in the relative energy loss (within the ranges considered in this study), and the optimum relative baffle block height hb/y1=0.77 to 1.7 and bed slope is 1/50.

عملية الحفر في المناطق اسفل المنشآت الهيدروليكية واحدة من اهم العوامل التي تؤثر على استقرارية وتشغيل تلك المنشآت. الطاقة المتولدة الكبيرة في منطقة اسفل المنشاءات يجب ان يتم السيطرة عليها. لذلك يجب تصميم منشأت التشتت لتبديد هذه الطاقة الكبيرة والحد من اعمال الحفر المرافقة لها. احواض التهدئة ذات المهابط الاحادية او المتعددة واحدة من تلك المنشاءات المستخدمة. في الدراسة الحالية تم استخدام النماذج المختبرية لأحواض تهدئة مختلفة الابعاد احادية المهبط و ثنائية المهابط المتعاقبة. كما وتم دراسة تأثير استخدام العتبات النهائية و المصدات بمختلف الاحجام والميول في احواض التهدئة. المتغيرات الهيدروليكية المصاحبة لجريان الماء في تلك الاحواض تم قياسها باستخدام قناة جريان مفتوحة مجهزة في مختبر الموائع في قسم الهندسة المدنية / كلية الهندسة / جامعة قاريونس. النتائج اثبتت ان استخدام العتبة النهائية قد قللت طول القفزة الهيدروليكية بنسبة 4% مع زيادة بسيطة في فقدان الطاقة. زيادة ارتفاع المصادات تسهم في زيادة التشتت وفقدان الطاقة وكذلك في زيادة الارتفاع المثالي للمهبط (العرض/الارتفاع = 6). في حالة المهابط الثنائية وجد ان فقدان الطاقة الاكبر يكون في المهبط الثاني. وجود العتبة النهائية في المهبط الثاني يزيد من قابلية حوث التهدئة بتشتيت الطاقة وبنسبة 5% تقريبا. وكذلك وجد ان زيادة ارتفاع المصدات يزيد من قابلية التشتت تحت ظروف التجارب المستخدمة تحت المحددات التالية:(optimum relative baffle block height hb/y1=0.77 to 1.7 and bed slope is 1/50) ER -