TY - JOUR ID - TI - Influence of Acidic and Salt Media on The Corrosion Behavior of Aluminum Matrix Composites Reinforced by Al2O3 Particles تأثير الأوساط الحامضية والملحية على سلوك التاكل للمواد المتراكبة ذات اساس المنيوم مقواة بدقائق الالومينا AU - Niven J.Abdal Kadir AU - Payman S.Ahmed AU - Saja Amer Abdul Majed PY - 2014 VL - 32 IS - 10 Part (A) Engineering SP - 2351 EP - 2363 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - Corrosion behavior of pure Al and Al/ Al2O3 composite with five weight percent of Al2O3 particles (5,10,15,20 and 25) were investigated in 0.1M H2SO4 and 3.5 % NaCl solutions at room temperature. The composites were prepared by powder metallurgy and their corrosion behavior were evaluated by potentiostatic polarization and scan rate 3mV.sec-1.It's observed that pure Al/Al2O3 composites exhibited excellent corrosion resistance in NaCl medium than in the H2SO4 media. The pure aluminum exhibited slightly superior corrosion resistance than the composites in NaCl medium but the composites had better corrosion resistance in H2SO4 medium. Insulator Al2O3 particles are perceived to act as inert material and degrade the integrity of the protective oxide layer on the Al matrix.Al/Al2O3 composites have lower corrosion rate than pure aluminum in 0.1 M H2SO4, but increasing of wt% of alumina led to increase the corrosion rate. While in 3.5% NaCl solution can be seen that corrosion rate of pure aluminum less than that for composites. Generlly, For certain material, the corrosion rate in salt medium less than in acidic medium.

تم دراسة سلوك التاكل للالمنيوم النقي والمواد المتراكبة المنيوم- الومينا مدعمة بخمسة نسب وزنية مختلفة (25،20،15،10،5) في 0.1 مولاري من حامض الكبريتيك و 3.5% من كلوريد الصوديوم في درجة حرارة الغرفة. تم تحضير المواد المتراكبة المعدنية بطريقة ميتالورجيا المساحيق وتم تقييم سلوكها التاكلي بالمجهاد الساكن عند معدل مسح 3 ملي فولت لكل ثانية.لاحظنا ان المادة المتراكبة ذات اساس المنيوم المقوى بالالومينا تبدي مقاومة تاكل جيدة في الوسط الملحي (كلوريد الصوديوم) مقارنة مع الوسط الحامضي (حامض الكبريتيك). وقد تبين ان الالمنيوم النقي يبدي مقاومة اعلى مقارنة مع المادة المتراكبة في الوسط الملحي لكن المادة المتراكبة كانت افضل مقاومة تاكل في المحلول الحامضي من الالمنيوم النقي.ان وجود المادة المقواة في المعدن الاساس تعمل على زيادة نسبة الكاثود الى الانود في المادة المتراكبة، وبالنتيجة يتم تكوين النقر من خلال التاكل الموضعي. الفحص المجهري الضوئي للنماذج بيّن وجود النقر وتاكل السطح. ER -