research centers


Search results: Found 2

Listing 1 - 2 of 2
Sort by

Article
Analysis of the Influence of Different EDM Parameters Using Taguchi Technique

Authors: S.H. Aghdeab --- I.A. Qasim
Journal: Engineering and Technology Journal مجلة الهندسة والتكنولوجيا ISSN: 16816900 24120758 Year: 2017 Volume: 35 Issue: 6 Part (A) Engineering Pages: 571-577
Publisher: University of Technology الجامعة التكنولوجية

Loading...
Loading...
Abstract

Electrical discharge machining (EDM) is a non-traditional material removal process developed in late 1940s has now become the most important technology in manufacturing industries. Taguchi technique has been applied for design of experiments with three input factors and their trinity levels utilizing L9 orthogonal array. The nine specimens were machined with different electrodes material where AISI 304 stainless steel had been used as a workpiece with kerosene as dielectric fluid. The major aim of this study is the evaluation to choice the principle specifications of electrical discharge machining with the assist of Taguchi technique and utilizing Minitab program in condition of material removal rate and electrode wear rate. The variance conditions examined during production the research on electrical discharge machining would be the electrodes material, current and workpiece thickness. The effect of each parameters and excellent performance variables will be achieve by means of ANOVA examination and conformed by investigation to enhance method.


Article
Surface Roughness Evaluation in WEDM Using Taguchi Parameter Design Method

Authors: S.H. Aghdeab --- V.N. Najm --- A.M. Saleh
Journal: Engineering and Technology Journal مجلة الهندسة والتكنولوجيا ISSN: 16816900 24120758 Year: 2018 Volume: 36 Issue: 1 Part (A) Engineering Pages: 60-64
Publisher: University of Technology الجامعة التكنولوجية

Loading...
Loading...
Abstract

Machining of hard metal is difficult by conventional method to obtain high accuracy where the dimensional accuracy is the main factor. Wire electrical discharge machining (WEDM) extensively used, which is mostly used in machining of conductive materials by using precisely controlled sparks that occur between a very thin wire and a workpiece in the presence of a dielectric fluid. This study serves in studying surface roughness (SR) of high speed steel (HSS) using taguchi method to design the experiment, this was achieved with utilizing different wire cut machining parameters and study the behavior of these control parameters such as pulse duration (μs), pulse interval (μs), Servo feed and Servo voltage (V) on surface roughness. It can be noticed that when servo voltage and servo feed increase the surface roughness decreases and when pulse duration and pulse interval increase the surface roughness increases too, and It was found with using taguchi parameter design that the best machining variables of combination setting is Servo Voltage (22) volts, Pulse on time (110) μs, servo feed (450) mm/min and Pulse off time (30) μs to reach to the minimum value of surface roughness and hence better surface finish.

Listing 1 - 2 of 2
Sort by
Narrow your search

Resource type

article (2)


Language

English (2)


Year
From To Submit

2018 (1)

2017 (1)